Who really cares the reason is confirmation bias and not actual sound quality!!
Fuses fuses fuses
Ok, this is about fuses
1- a standard Bussman fuse is UL approved. Are any "high end" fuses UL approved?
2- do any component manufacturers supply their gear with any of the usual suspects of high end fuses as opposed to a standard Bussman?
3- let's say fuses do make a difference. Given incoming power is AC, why could fuses be directional?
Not meaning to light any fires here-
thanks in advance
1- a standard Bussman fuse is UL approved. Are any "high end" fuses UL approved?
2- do any component manufacturers supply their gear with any of the usual suspects of high end fuses as opposed to a standard Bussman?
3- let's say fuses do make a difference. Given incoming power is AC, why could fuses be directional?
Not meaning to light any fires here-
thanks in advance
- ...
- 244 posts total
Someone, Anyone, tell me what to measure with an VOM or LCR meter or any other way to know what direction to drop these fuses in.... I really don’t want to listen to them a week each way to figure it out... If it is that obvious, someone should have figured this out... So There is no way, it’s all voodoo. The minuscule amount, (millionths of ohms) that claim to have been measured can be attributed to all sorts of things as Almarg explained numerous times. And let just say there was a millionths of ohms difference, do you think a regulator that sits next in line in the circuit would care one iota!!!!!!! this is all BS and so are the people that claim it to be so. what about the dirty plug wiper contacts in your power point. What people are hearing is are fuses that have seen too many turn on cycles which sags and carbons/corrodes them up, just replace for the same $1 fuse and your good to go. Here is the same fuse that has seen too many turn on surges, over time left to right. https://i.stack.imgur.com/0uqWX.jpg Cheers George |
- 244 posts total