2. tech-talk
  3. 130709-12450

Directionality of wire

I am a fan of Chris Sommovigo's Black Cat and Airwave interconnects. I hope he does not mind me quoting him or naming him on this subject, but Chris does not mark directionality of his IC's. I recently wrote him on the subject and he responded that absent shunting off to ground/dialectric designs, the idea of wire directionality is a complete myth. Same with resistors and fuses. My hunch is that 95% of IC "manufacturers", particularly the one man operations of under $500 IC's mark directionality because they think it lends the appearance of technical sophistication and legitimacy. But even among the "big boys", the myth gets thrown around like so much accepted common knowledge. Thoughts? Someone care to educate me on how a simple IC or PC or speaker cable or fuse without a special shunting scheme can possibly have directionality? It was this comment by Stephen Mejias (then of Audioquest and in the context of Herb Reichert's review of the AQ Niagra 1000) that prompts my question;

Thank you for the excellent question. AudioQuest provided an NRG-10 AC cable for the evaluation. Like all AudioQuest cables, our AC cables use solid conductors that are carefully controlled for low-noise directionality. We see this as a benefit for all applications -- one that becomes especially important when discussing our Niagara units. Because our AC cables use conductors that have been properly controlled for low-noise directionality, they complement the Niagara System’s patented Ground-Noise Dissipation Technology. Other AC cables would work, but may or may not allow the Niagara to reach its full potential. If you'd like more information on our use of directionality to minimize the harmful effects of high-frequency noise, please visit http://www.audioquest.com/directionality-its-all-about-noise/ or the Niagara 1000's owner's manual (available on our website).

Thanks again.

Stephen Mejias
AudioQuest


Read more at https://www.stereophile.com/content/gramophone-dreams-15-audioquest-niagara-1000-hifiman-he1000-v2-p...


128x128fsonicsmith
nonoise's avatar
nonoise
10,825 posts
 
Here we go again. 😧
geoffkait's avatar
geoffkait
23,365 posts
 
It’s always great when some excitable new person comes along and starts a new thread on wire directionality, especially when he is a skeptic. It’s a little like telling the same joke over and over to someone with a memory disorder - even though he’s heard the joke before he still laughs heartily. A good time is had by all. 😛 Let’s rock!
don_c55
1,025 posts
 
Single ended interconnects are directional because they are grounded at the source end only, for lowest hum pickup and resulting low noise. 
geoffkait's avatar
geoffkait
23,365 posts
 
But the OP specifically excluded single ended cables from the discussion. That’s why he also included fuses in the discussion. Fuses, as far as I know, are not single ended. The OP is discussing wire per se.
randy-11
1,913 posts
 
if you want directionality use diodes
More to discover