2. amps-preamps
  3. 1448317474

Synergistic Red Fuse ...

I installed a SR RED Quantum fuse in my ARC REF-3 preamp a few days ago, replacing an older high end fuse. Uhh ... for a hundred bucks, this little baby is well worth the cost. There was an immediate improvement upon installation, but now that its broken in (yes, no kidding), its quite remarkable. A tightening of the focus, a more solid image, and most important of all for my tastes, a deeper appreciation for the organic sound of the instruments. Damn! ... cellos sound great! Much improved attack on pianos. More humanistic on vocals. Bowed bass goes down forever. Next move? .... I'm doing the entire system with these fuses. One at a time though just to gauge the improvement in each piece of equipment. The REF-75se comes next. I'll report the results as the progression takes place. Stay tuned ...

Any comments from anyone else who has tried these fuses?
128x128oregonpapa
tommylion
874 posts
 
a25105,

Good question. The description says they work for inputs as well as outputs. The unused input on my DAC is BNC, so I’m unable to try it there.

They also have RCA shorting plugs for unused analog inputs on a preamp or integrated. I have had similar "caps" on my passive pre for some time. Maybe I will take them off to hear again what difference they make.
tommylion
874 posts
 
Thanks Al,

Those BNC terminators are cheap enough that I think I'll try one on my DAC, even though it sounds like inputs may not be an issue.
dlcockrum's avatar
dlcockrum
2,190 posts
 
Hi Al,

Would one need to solder a 75 ohm resistor between the live and neutral on this BNC connector to produce a shunt? Or simply plug one of the shunt connectors tommylion refers to into this BNC plug? Looks to me like those  shunt caps above could be replicated using an inexpensive RCA connector and a 75 ohm resistor...

Dave

almarg's avatar
Ag insider logo xs@2x
almarg
9,670 posts
 
Hi Dave,

The part that I linked to has a 75 ohm resistor built into it.  And since it is intended for use in video applications (I have used it for that kind of purpose) I would expect the resistor that has been chosen to be suitable for use in terminating the RF frequencies that are present in digital audio signals.

Best regards,
-- Al
 
dlcockrum's avatar
dlcockrum
2,190 posts
 
Thanks as always Al. That cleared it up.

Dave
More to discover