I keed your help??, re my whole system

@Daveyonthecost - have you considered upgrading your cables?

A company called KLE Innovations is in your neck of the woods (i.e. Brisbane, Australia)

Their products will provide excellent control, deep, well controlled bass, exceptional clarity and image. The should work well with your setup.

I have had the pleasure of auditioning most of their lineup and these two products I feel provide the best bang for the buck in their lineup are
- gZero20 Interconnects
- gZero6 Speaker cables

Do not be put off by the slimline look of their speaker cables - they provide an exceptionally deep and well controlled bass performance

I have not tried their power products but think they too should provide significant improvements, based on the improvements their other products provide

I see you are using XLR. I have compared the gZero3 IC’s to a Kimber Kable silver XLR interconnect and the gZero3 outperformed the XLR, so don’t be afraid to try them.

If you are into DIY solutions you could try the cables in this link
http://image99.net/blog/index.html

I have developed these cables over the last four years and believe the materials identified in the link provides the best bang for the buck.

Another Audiogon member @toddverrone has built all of these cables and seems extremely happy with them

They provide excellent sound quality with superb imaging, dynamics, clarity and control.

You will also find my reviews of the KLEI products there.

I have compared some of the KLEI products from some well known companies such as Kimber Kable, Cardas, Van den Hul, Chord, crystal cables, DH labs, Purist Audio, Tara Labs and Signal Cable and the KLEI products outperformed all of them.

Unfortunately - all of these cables identified above take around 400 hours to sound their very best, and at about 25 hours some cables start to sound a little odd until the 60 hour mark is reached. Then they start to perform extremely well at around 150 hours and continue to improve - so burn in can take some time

Regarding the effectiveness of cables I know there are two camps - personally I value my cables as much  as my components (if not more) . I have found they make a huge difference in the performance of each connected component. Some components actually run cooler by around 6 degrees Celsius, all due to the cables

My system is towards the budget end of this hobby, but it performs to a much higher level thanks to the cables

Hope that helps

Regards, Steve

Thanks Ramonda
The loading I'm using, are 100 ohms and 150 ohms, you stated that maybe using less loading, but isn't 200-400 ohms is more not less ??, to be honest I don't really know how the loading works?, can you put me on the right track??
Many Thanks for all of the other suggestions
David

What he means by less loading is to increase the value of the resistance that is terminating (loading) the cartridge.The increase in terminating value is referred to as "less" because the higher value pulls less current from the cartridge.

Also the quality of the loading resistor is something commonly overlooked. I always advise to use common resistors to dial in the value. Then, once you find a value you like, search out a foil resistor (Caddock mk132, Vishay Z-foil...) and use that.

BTW some DL-103 users like to terminate their carts with really high values, like 5k ohm.

I like the DL103r with variable active loading from 300 to 50 ohms.

Moving to the U.S. may be the best use of $$$??? Ha ha!