Classe Sigma SSP and Rel S3 connection issue

Just a Thought if you set to full and No Sub the LFE should be routed thru mains Without needing a second .1 connection as well Could be an issue there if you are using both.

Waaaait what did you set the delays and distances to for the .1 AND the front LR

Can you tell me how do I PM you privately?

I thought I could pm within the system Naplesisnotmyhome@gmail.com
239-353-1060 I will be home now until later, will walk you thru the checks. something is definitely off

Joe

What Amp are u using? Can u also tell  me how do u config your setup. Did u set all speaker to small and croas at what hz? What level u set your sub to? And are u using eBass? I am assuming u are quite happy with the SVS. Did u connect the SVS using the sub out in the Sigma SSP? Thanks.

Citadel 1.5s for the front left and right, running balanced, using a proceed amp5 for my center, surround channels

And my 2ch config is full range under configuration 2 no other speakers enabled

My multi channel config
Mains cross at 40hz -3db at 35
Svs crossed.at 40
Group and eq measured with roomeq wizard
Delays were tape measured

My mains have active subs, so my config is unique and no lack of clean low bass in either config

What do you your rew plots look like and spl readings 75db weighting type c