Classe Sigma SSP and Rel S3 connection issue

Just upgraded to the latest firmware last night 1.0.3.14. It doesn't seems to make any difference. I still have no mid bass when enable subwoofer and eBass in the speaker setting. I am using slope of 12, no Peq and no tone. How is your setup? Do you feel u got enough bass ? My Sigma SSP is brand new from Classe not a demo.

Remember Ebass Routes Lfe to the Mains AND the SUB So it might be a cancellation.

No PEQ = check the Checkbox Group enable and the front LR and Sub Groups just to be safe
Under Controls Disable The Tone Controls

Just so we can eliminate a second system issue
Take a second config (Config 2)... set front LR to FULL
Assign a source 2 channel audio.. see if the midbass is there Just by process of elimination, then switch over to config 1, turn Ebass off

60, 

We can take a blank memory stick back the config and reset the prepro (menu 1 2 3) on the remote.. and then see if its something in your config... I suggest its cancellation... And I take it you checked set and measured delays

Notes Config 2 Set everything to off, the mains to full And See what you get with a 2ch source set Just to eliminate other system issues, I have 0 LFE issues

Snell Xa90PS powered by citadel 1.5s(balanced)
SVS PB13

If you PM me I can try and walk you thru it.

Just a Thought if you set to full and No Sub the LFE should be routed thru mains Without needing a second .1 connection as well Could be an issue there if you are using both.

Waaaait what did you set the delays and distances to for the .1 AND the front LR

Can you tell me how do I PM you privately?

I thought I could pm within the system Naplesisnotmyhome@gmail.com
239-353-1060 I will be home now until later, will walk you thru the checks. something is definitely off

Joe