Design a $60,000 Speaker - Start here


Hi Everyone,

Just thought for interest I'd talk about one of the most expensive woofers in the 10-12" varieties, the Accuton AS250-88-552 CELL, actually an 11" aluminum honeycomb sandwich construction. Retail price at hobbyist volumes: $1,400, each.

In addition to the exotic material, the suspension and motor assembly are also worthy of note, as they leave a very large amount of unobstructed space directly behind the dome, allowing it to behave most ideally like a piston.

So putting this together into say a modest 3 way with all drivers from the same company and of the same level, I estimate around $6k / pair of speakers for the drivers alone. Add the normal markups, and this is a $60k speaker.

Will it sound any good? I have no idea. I just wanted to share with you all where some of these speakers that cost as much as a luxury sedan get their prices from.  Obviously, my estimates are rough, and go up and down. The point of this is just a general expose.

Best,


E

erik_squires
I wanted to emphasize, this thread was just to talk about one way to get to a $60k price point. Not that it would sound good, of 30X better than a $2k pair of speakers. :) 


missioncoonery,
 
Yes you are correct I'm proud to be the Tekton's #1 cheerleader but with no vested difference.

The difference between me and you,is even though I get out and about and listen to all kinds of top speakers and if I Remember correctly you have never heard any Tekton's.

I have absolutely no need for spl's above 100db peaks at my listening position 10 ft away,I have taken care of my hearing all these yrs and can still hear above 15k.

Remember my budget for speakers could easily be 40k but I hear and see no reason to spend that much.

With all that being said I most definitely take anything you say with a grain of salt as well.

The Vivid speakers that I have heard were harsh from 2k in frequency on up and basically ran me right out of the room.

They do have a really cool style to them though.

Kenny.
Also, sorry should have been more clear:

I've never listened to Tektons. I meant the price/parts ratio is very good.

I'm talking about consumer parts here. JBL/ATC/TAD have what we may consider outrageous priced drivers intended for high power/continuous duty.

Better? I know of at least one mega movie score producer who gave up on his mega speakers because he could only hear them when played loud.

Listening style matters, as does lack of compression in normal use.

Best,


E
@erik_squires     

I don't know about Magico but modifying a mass market driver doesn't sound like engineering but more like tweaking. If a run of special drivers is made for them by the OEM then what happens when they run out - owners are left with no spare parts...no problem on a $500 speaker or $300 lawn mower but not good on something more costly that is meant to last decades.

Vertical integration allows companies to support their products for a lifetime which is a different philosophy and a different target customer. Obviously this  should be important to speaker owners in $10,000+ speaker market as it could be frustrating to find that your beautiful speaker is only good for the landfill after only 5 years and a costly mistake that blew up a couple of drivers....

Vertically integrated companies should have all the tools and equipment in house to make replacement parts long after those who use entirely outsourced manufacturers have long run out of spares. It is a very different philosophy with long term horizons with customers that do not intend to replace their equipment for possibly a lifetime....



Or you could buy some high-quality vintage drivers.  Let's see, a matched pair of Jensen M18 field coil woofers with Western Electric power supplies would be nice, but then that would eat up your entire $60K budget.