Best Bang For The Buck I've Ever Spent

The Best Bang For The Buck I Ever Spent?

( The azimuth adjustment on an ET arm is easy!) I don't know what the above poster is referring to?) He states it's high pressure... that's what the end user has paid for. It doesn't have to be.)

Well, let's see...

If you're referring to before I knew JACK....or after?

If After.. here goes..

(1) Learning that there are inexpensive ways to isolate components if you have the where-with-all and the equipment.
(2) Learning about a single unit that replaced others when I had an ET arm in my system to damp pulses from my compressor and, in addition that would dry out any moisture,
(3) The Mark Baker belt for my Rock 7.
(4) My mat material I currently use on mt TT's.

bdp24,

If you're looking for Trans-Fi info, I'd seek out dgarretson.

The Tweek Geeks Sonic Tonic bottles.
ozzy

@slaw 

( The azimuth adjustment on an ET arm is easy!) I don't know what the above poster is referring to?)
I guess that you are referring to me. I said, "it’s hard to see that the azimuth adjustment can be anything like as fine as the Trans-Fi, which has a 2 inch adjustment base, which yields adjustment increments of 5 minutes of arc."
You will note that (1) I did not say that azimuth adjustment on the ET was hard, as you imputed to me, and (2) I did not categorically state that the adjustment was not as fine. But I suspect that it is not - or can you get stable, repeatable 5 minutes of arc adjustment? If so, that's useful information, and I would prefer to be corrected.

"He states it's high pressure... that's what the end user has paid for. It doesn't have to be.)" I stand corrected. Thank you.
 

The Best Bang For The Buck I Ever Spent?

Epoxied a brass plate to my Denon DL 103 cartridge - $12 in total

Turned a good cartridge into an excellent cartridge.:-)

See:
http://image99.net/blog/files/23c020f75290d3392577113371f4dc94-38.html

Regards...