2. speakers
  3. 131564-7172

Vandersteen 2wq with Mccormack dna .5

Fellow audiophiles,
If there are folks out there using A Vandy 2wq sub with Mccormack DNA 0.5 amp then then I would like to know what value of crossover is working for you. I have tried 100k, 75k and 50k fixed crossovers and it all sounds the same to me. I have the crossover box and played around with different settings but haven't quite felt that 'aha' moment. I have had this combination for over a decade and the system has been used in various homes in rooms of different sizes. It has sounded different in different settings but has consistenly left me wanting for more. Am trying to figure out if there's something that is truly wrong or whether I should stop wasting my time and live with the way it sounds. Any feedback is appreciated.
uditnaik
hifiman5's avatar
hifiman5
1,832 posts
 
OP  I have a modified DNA-1 connected to two 2wq subs. I have the M5-HP crossover set to 75K as the amp has a 100K input impedance.  I found that to provide excellent integration of the sub with the system.  Have you adjusted the output level and the "Q" control on back of the 2wq?
hifiman5's avatar
hifiman5
1,832 posts
 
OP  What main speakers are you using?
uditnaik OP
20 posts
 
Hifiman5,
My main speakers are 2Ce Sigs II. I have Kimber PBJ running between the amp/preamp(Mcintosh C27) and the sub is connected using the standard cable that came along with it (I believe it is Audioquest). Speakers are biwired using Schmitt audio cables. I have been tweaking the Q and the volume control and between the placement and tilt of the 2CE's, I am going through an 'analysis paralysis' syndrome. At this point I have just given up.. Room acoustics could also be a culprit but that's a lot of change to get a rig like this to sound right....
gdnrbob
4,459 posts
 
You can also adjust upwards (above 100K). I used the M5-HP with Vandy 3a sigs and Treo's. with a DNA-1-which has 100K ohm. I definitely heard a difference between 150K and 75K, with the bass becoming more pronounced as I proceeded lower.
1 question: how old are the batteries in the crossover? Are they near expiration?
Lastly, I would PM or call John Rutan at audioconnection (that's his Agon ID). He can give you detailed info on how to set up the subs/speakers far better than I can.
Bob
uditnaik OP
20 posts
 
Bob,
Thanks for the tip. Will try to go a level higher and see if there is any difference. I am not using the M5-HP. I have three sets of fixed crossovers (100/75/50) that I bought from Vandersteen/ebay over time. That’s one of the reasons why it also gets cumbersome to keep toggling between the values.

I will call JohnR and pick his brain on this topic. 
More to discover