Why do turntables sound different?


Let's consider higher-end tables that all sound excellent. Same arm/cartridge and the rest of the chain. Turntable is a seemingly simple device but apparently not quite or not at all.
What do members of the 'scientific community' think?
inna

The corner is the strongest part of a suspended wood floor.  The corner of my room is approx 22 feet away from my speakers. You cannot feel any vibration when standing in front of the turntable stand. You can feel the floor vibrate a bit when standing behind my speakers. I rather have my turntable and all my front end gear (which is tube) as far from my speakers as possible.


@lostbears, take a spl meter and measure the acoustic energy in the corner, you will be very surprised how much energy is concentrated in the corner compared to other locations in your room
rsf507,

There are multiple options available. I only stated one of mine. I did not rule out racks, isolation footers, spikes etc.
Thank you for including platforms like minus-k and Vibraplane. Let's not forget that Herzan platforms are available too. 
 
ICs and SCs are one of the options that I have chosen.

I do Like to spend $ on Older Whiskey, Faster horses, Younger Women and Audio. The rest; I am just going to Waste.

Best to All on this Journey 
They sound different for two reasons.

1/  The design choices of suspended, lightweight or mass and                implementation of materials choice and the drive method used.


                                                                                                               
2/  The use in the home environment from either proper, or poor set  up, in both basic parameters and adjustment ,and final placement.                                                                                                                                                                                                                                    





So far scientists among us don’t participate, and I suspect I know why - they have no idea.
If all seemingly great turntables sound different, than perhaps none of them sounds quite right. Each distorts and colors the sound in its own way.
I would also assume that mechanically matching table and arm could be important. And cartridge is the third element. Maybe all three should be matched ?