Aragon 8008x5 with Vandersteen 2w

(((I do have the WX2 box but believe it is defective.))
((( None of that matters if I do not have various capacitors to try.)))

This is what the assessment Box does it finds out what the correct
settings are.
Some folks can have the switch backwards all are set to open except the dip switches for that specific input impedance setting.

Its real simple set the dip switches to close at 50 K in the WX2 Box
Install the assessment box temporary trial unit with your preamp outputs running into the input RCA ((( Input))) section of the box take the (((output))) of the box and plug it into your amplifiers RCA inputs.
Grab your Voltmeter and set to AC Volts under 10 scale
Put the red probe into the Left Channels Red Speaker binding post jack
Put the black probe into the Left Channels Black speaker binding post jack
make sure they are snug
Play track 27 on Vandertones and adjust your preamps volume control
to you see 1 Volt AC on the meter. if you cant nail 1 volt get it adjusted so your as close as possible .98 1.05 whatever
Now go to Track 31 and when you see .707 or close to that you nailed it.
This is all the same for Quatros but done at Track 30
Let us know how your doing
or call JohnnyR at Audio Connection
9732391799

real service !
thanks Johnny R

Thanks for the replies everyone! I do believe I am performing the procedure correctly. I have used the sub-woofer with 2 other amplifiers with no problems.  

I just spoke with Richard on the phone. He believes the problem with the using the 2w with the Aragon balanced circuit may be in the design of the amplifier. He suggest that I attempt to get the combination running using single ended connections. 

   

Don't forget to use the xlr shorting pins for the channels that will be used with rca output.