2. amps-preamps
  3. 132245-34152

Aragon 8008x5 with Vandersteen 2w

Hello everyone, 
     I know this is a long shot but is anyone using the above combination. I am attempting to find the correct balanced crossover. I have 20K RCA, 150K balanced, these do not sound good. I do have the WX2 box but believe it is defective. I have downloaded the Vandertones and am using a multi-meter to check AC voltage at the speaker. None of that matters if I do not have various capacitors to try. 

So.... since I do not know the correct input impedance for this amp, does anyone have one they are using successfully with a 2w series sub-woofer?

PS, the advertised spec I found for the amplifier is 22K single ended. The 20K single ended crossover does not sound or measure correctly. I believe the impedance for the 8008x5 may be different from an 8008. Speakers are Vandersteen 2ci.

Thanks in advance!       
jwmorris
jwmorris OP
46 posts
 
I promise I am not ignoring advice from Richard or John at audioconnection. When I spoke with Richard he even suggested I call Johhn (audioconnection), that speaks volumes!

I have tried to connect the sub several times over several months via RCA (single ended). 

I believe I have a bad WX2 (temporary) crossover because my voltage readings change without me making changes in the WX2. 

What I need is a known good WX2 to determine the correct crossover to order. The dealer closest to me did not have a WX2 to lend.  

For the record I have a history of electronics repair, installation, and troubleshooting. I have also used the sub-woofer successfully with other amplifiers.

I came here knowing I would receive good advice and acknowledging I may be making a mistake. I appreciate all the help, and I have not given up yet. Thanks to all that have replied. 
gdnrbob
4,444 posts
 
I have a set you can borrow.
I'll PM you.
Bob
jwmorris OP
46 posts
 
Thank you! I will send you a PM.
audioconnection
1,271 posts
 
What kind of Voltmeter?
  FYI Harbour freight has a decent one for 23 bucks.
 Best JohnnyR
jwmorris OP
46 posts
 
Hello everyone, I was able to borrow a WX2 from gdnrbob and do some more testing. Thanks gdnrbob! I measured the following using a Sears multi-meter. In each case my ears confirmed what the meter was telling me. All readings are using track 31 of the Vandertones after setting track 27 to the appropriate 1 volt AC reading. 


200k settings     .26 volts 
100k settings     .487 volts
50k settings      .755 volts 
33k settings      .849 volts
20k settings      1.050 volts 

Based on those readings I will buy a new or used 50K crossover. I believe the advertised impedance of 44k balanced for the Aragon 8008, is actually 44k single ended for the Aragon 8008x5.

One concern I have is if my crossover was old enough to read incorrectly, it is very possible my sub-woofer is not operating within specifications. If my sub-woofer is out of spec will it throw off the voltage readings? I will cross that bridge later.   

I will post pictures of the old crossover versus the newer one at a later date. Happy Thanksgiving!    
More to discover