Best way to decrease the internal volume of a sealed speaker?

In most cases there is way too much stuffing, fiberglass or whatever, in speakers. The best results will be obtained by removing most or all of the stuffing. Let the speakers breathe. Any high frequency ringing, etc. internally can be handled with a small amount of hollow fiber wool, about the size of a grapefruit. 🍊The worst thing I found with bass drivers was the dust cap ringing. That can be addressed with a small damper such as the Acoustic Disc from Golden Sound.

Ozzy 

The Cascade can be applied by a heavy brush or even trowel like device. I have used this product on several cabinets. I kept track of the volume installed by using a platic cup filled to volume. You want the same = amount in each box. Apply more to all joint seams and corners as this will further stiffen these areas. Drys to a concrete like substance and grainular in feel. The micro bearing fill added in the gallan pale will add more mass and will be even more dispersive to resonance. I prefer long hair sheeps wool as fill material. You could even add non ferrous rods installed near each internal corner but this may alter the cabinet cosmetics while improving the sound. Dont add any right angle shapes to the cabinet..More you can do with the driver and mounting...good luck. Tom

Use Styrofoam blocks - easy to install and easy to remove too

Best of Luck

Peter

toddverrone,

Will the expandable foam absorb sound like the other products such as wool, fiberglass etc.? If so I think that would be the opposite of reducing the internal box volume. That's why I thought of sealing the exposed area with the Flex Seal spray.
Cutting the pieces of mdf wood and installing them as you suggested might work. I guess I worry that the glued wood may come loose and then rattle or move around.

theaudiotweak,

I will look into the Casacde V sounds interesting.

Geoffkait,

I agree and I was intending on limiting the amount of fill used.

pbnaudio,

Will the Styrofoam blocks absorb? Should I coat them with something?

ozzy

Ozzy

I agree with Geoff limit the amount of damping material. The Cascade reduces the drag of the glue and saw dust and increases the dispersive area of its solids. MDF which is probably in use here..sounds like a dark muffled congested cough..the Cascade seals out that character. The sheeps wool acts like a comb filter rather than damper of character. Tom