Vandersteen Treo Speaker Cable Suggestions

For those of you using Clear Day Audio Double Shotgun cables, how do you recommend bi-wiring these? (my amp only has one pair of speaker terminals)

Do you use jumpers, or just stack the spades? Sorry if this is super obvious, but again, new to bi-wiring here, so appreciate the advice.

Thanks!

gritter2,

I have two pairs of speaker terminals, so no problem here.  In your circumstance you can stack the spades (Clear Day cables are terminated in relatively thin but high quality silver spades). What you could ask Paul is if he can run both pairs of Double Shotguns into one pair of spades at the amp end.  Note:  Paul uses smaller high quality silver spades at the speaker end to accommodate to the terminal strip at the back of the Treos as it is hard to fit full size spades.  In other words, if you call Paul and discuss it, he will tell you what he can do.

As you can tell from your thread, Paul's cables mate well to Vandersteen's as many of us have had the good fortune to use them in our systems. I would strongly suggest you give Paul a call and chat with him.  At worst, you'll have an enjoyable conversation.  He will be straight with you and not pitch his cables.  They speak for themselves. 👍

All the best! 

looks like Clear Day plans to be up and running January
you are welcome to borrow the 12’ LFD i mentioned till you can get his cables....

thin spades are good, you want what is called a gas tight connection stacking is acceptable but you will need to be hyper vigilant to maintain a great snug connection

if Paul can terminate the two runs into single spades at the amp end that is by far preferrable

@tomic601  Right on point! 

@tomic601 Thanks for the generous offer!

I will be reaching out to Paul shortly to see what he can do and will report back.