Best Budget Phono Cartridge?


After upgrading my system for CDs and SACDs recently, I pulled my old turntable out of storage to see how it would stack up. It sounded pretty sick, and my best guess is that an old (very old) Stanton 681EEE is the culprit. I don’t want to spend a lot of money on this experiment, but if I can find a decent cartridge in the $100-250 range it would be fun to see how my old vinyl compares. I’m looking at the following new or NOS cartridges:


Audio Technica AT7V MM or AT-F2 MC

Denon DL 103 MC or DL 110 MC;

Grado Prestige Gold1

Sumiko Pearl MM  

Ortofon 2M Blue MM  

Shure M97xE

 Would any of you like to weigh in on this list, or add a favorite of your own? I’ll be inputing to a Parasound New Classic 2100 preamp.


128x128cheeg
Post removed 
cheeg 01-11-2018 2:36am
... the Pfanstiehl 4822-DEE-P is a decent replacement stylus, at only $29 -- that's a no-brainer! At worst, I can use it as a backup set of "rock skis", for my rutted records that would otherwise tear up good needles.
Provided your records are clean, there's really no reason to be concerned that a worn record will damage your stylus. It's the dirt that can damage it, not the groove -  although I am assuming here that these are discs that haven't been trod over with football cleats.
Thanks to the moderators for deleting the hateful post above. It's difficult to believe that matters such as VTA could invoke such nastiness. To clarify, there is no such thing as a "negative VTA." Claiming that there is reflects an ignorance of the geometry of phono cartridge alignment. Here is a link to a graphic that clearly illustrates VTA and SRA and shows how they are related - but very, very different - angles.

Understanding these angles is key to achieving proper phono cartridge setup. However, it is critical to also achieve proper overhang and tangency in phono cartridge setup. That is why I always recommend using a mirrored gauge such as the Mint or WallyTractor, which align the actual stylus/cantilever assembly, and don't rely on the cartridge body or anything else to get those parameters correct.
Post removed 
 Sounds like I missed an interesting post- @viridian and @cleeds obviously disagree on how to refer to VTA, so I will read up, and draw my own conclusions. Nevertheless, thank you both for trying to educate a newbie.