Looking for not too expensive Turntable


I want a vintage turntable for a second system with a tube amplifier. I read the Pioneer PL-12 is good sounding without any jitter due to being belt drive. I can actually hear jitter. I owned a direct drive TT and it had jitter. My Garrard 401 did not have any jitter either. Suggestions? Pioneer PL-12 good?

fisher_400
Tons of choices under $250 on ebay.  Just budget enough for a new cartridge or stylus.  A cheap and cheerful Ortofon Red, Grado or Audio Technica should do the trick.
@lewm 

Denon DP80 can "beat" SP10 Mk2 by a small margin. Can be found for $600 to $900. (I owned them both, both in custom slate plinths, ran them side by side in my system. End of editorial.)
 The OP said the budget is $250 for the whole system 
If one was buying new, the Audio Technica LP-120 comes with a AT-95E cartridge. A friend of mine owns one and it seems very well built for the price (~$250 Amazon). I would also check out Music Direct, The Record Doctor, and Audio Advisor for alternatives.   
Dear Chakster,  I guess I was responding to your bald statement that "nothing" can beat the SP10 Mk2, presumably in its price range and in the category of vintage direct-drive types.  My remark was just meant in fun.  However, I agree that "below $250" is not the price range for either the DP80 or the SP10 mk2.  I've held on to my DP80, even though I do not use it regularly, just because the market value is so ridiculously low compared to its capabilities.  (I listen to the SP10 Mk3 and the Kenwood L07D most of the time.) I'd prefer to have the DP80 around just to look at, rather than to sell it for the too low price it could command.
I don’t know any other top class turntables with such a high torque like the SP-10mk2 (or mk3). In terms of usability this is the best, i wish all my DD could immediately start/stop like the SP-10mk2 or at lest like the Technics SP-20. But none of them (Luxman PD-444 or Victor TT-101) can compete with Technics torque. Never tried Denon, but i’m sure the platter is like Victor’s. I know they have another advantages and i know why the torque is not that high and the platter is not so heavy. But for usability the high torque is amazing feature, that’s why it was studio broadcast turntable, that’s why even lower technics are "disco" turbtables.

The visual part of the hi-end gear is important for me too, i prefer the classics, in terms of design those SP-10mkII, SP-20 are so nice (but not in the stock obsidian plinth, imo).