This was an extremely painful thread to read. It was like listening to the Democrats and Republicans in Congress. I have an open mind as I did when I purchased various fuses. I really think upgraded fuses helped my high end system just like upgrading my power cords. If you are a naysayer and an audiophile, I have to believe $300 is not going to break the bank. If it will you are probably not an audiophile and tweaks in sound improvement shouldn't even be discussed. I have wasted $300 on many things in life. If I can improve my system for $300 then i will give it a try. If it doesn't improve, I just move on to something else. Currently, I have been testing various power tubes for my Raven Amp. It is fun to hear the subtle differences amongst the different tubes.
Based on what I read, I will apple the substance to all component fuses and speaker connectors and the male end of the power cables. I assume I do not have to take them apart. If I do then this is not for me. I am hesitant about applying to the tubes in my amp. It is already hard to take the tubes in and out and I don't want grease anywhere near my amp. I am not sure where you would apply the solution to the actual wall socket which is already an upgrade. In my theater room, I have an Laser Epson 10000 projector. Are you saying that it will improve the picture quality of the projector if I apply to the power connector? Based on what Frank said, I can brush the solution on and not have to wait until it dries or cures before plugging back in or connecting. Am I missing anything?
Based on what I read, I will apple the substance to all component fuses and speaker connectors and the male end of the power cables. I assume I do not have to take them apart. If I do then this is not for me. I am hesitant about applying to the tubes in my amp. It is already hard to take the tubes in and out and I don't want grease anywhere near my amp. I am not sure where you would apply the solution to the actual wall socket which is already an upgrade. In my theater room, I have an Laser Epson 10000 projector. Are you saying that it will improve the picture quality of the projector if I apply to the power connector? Based on what Frank said, I can brush the solution on and not have to wait until it dries or cures before plugging back in or connecting. Am I missing anything?