my first hight end sound system , please don’t ignore


hello my audiophile friends !!
out of my passion for good music i have decided to build my very first hight end audio system , i bought a pair of dali euphonia ms5 in mint contition with very few hours on them, an edge NL10 power amp , a  benchmark dac3 pre amp , 3 runs per speaker - tri-wiring terminated with high-end plugs “ rea cable “ wires made from pure silver , and 2 RCA stereo pair ,, my next purchase will be a power supply and i am currently building a table for my audio eqiipment made from granite and sorbothane , i also bought TDK clip on Emi Rfi filters , and hight end Single Crystal Copper Power Cords ,, i will start slowly doing my researh for turntables and hoping not to spend more than 3000, 3500 on that , 
i’m i in the right path ? i would apreaciate tips suggestions and help , i am new to this with some basic  understandings about audio equipments
128x128dimitris7
Dimitri,
 If you can run dedicated lines to your audio room (you are an electrician), you should do that. When you do, remove all the filtering stuff (some audiophiles will disagree) and plug all our equipment directly into the outlets. Listen for a few weeks.
 Sell all the filtering nonsense and buy more records.
My humble opinion...
Oregon,
thanks for the advice, i will definitely try both ( with filters and without ) and have that in mind
also i just bought a power plan for all my audio equipment , i think it was the best think to do
I have to agree w/ oregon. Personally I tried using a power plant only to discover that my system actually sounds better without it as long as I was on dedicated electrical. A power plant benefited my system somewhat when I was unable to run dedicated power lines; was quite the opposite when I finally got a place where I could do sole use electrical.
In no way do I have disrespect for power plants; they can serve well if there is a lot of noise & / or devices on the same circuit. In my case I heard a lower noise floor - but dynamics suffered.
In a dedicated electrical environment, I did discover that power cables made more of a difference, making a very good system sound rather stellar, especially if you can run good wiring along with good power cables!
Hope my experience helps; Enjoy The Music!
thank you ericjcabrera !! 
question...
does the dynamics also depends from the power plan? ,, i bought the ps audio p10 , and ofcourse with good power cables and wiring 
Try listening with & without power plant; I think your system will be very revealing of the effects, probably even more so than my system. For mine, after dedicated lines, I ended up selling the power plant in favor of being without it & have never turned back.

As for power cables & wiring; when I got dedicated power, I experimented with running my entire system on generic run of the mill cables & then all high end power cables. The difference is nothing short of amazing; I cannot explain why, only that I definitely hear a marked improvement w/ high end cables. Cleaner sound, lower noise floor, much improved three dimensional holographic imaging, less fatigue & the list goes on . . . 

The other cable I upgraded to high end was speaker cables; they made almost as much if not more improvement than power cables did. Upgraded interconnects made less improvements for my system than did the aforementioned; I stuck with mostly silver on my single ended IC’s & copper for my balanced IC’s.