2. cables
  3. 134268-85386

Conditioning/Burn-In Method

DISCLAIMER
Potentially controversial subject matter ahead. Thus post is recommended for mature audiences only. If you're in the school of thought that cables are voodoo, this post is not for you, please move among.

Now, to business.

I'm in the process of working in a set of Signal Cable Silver Resolution XLR interconnects between my DAC, Preamp and Amplifier. So far, I probably have only 20 hours or so of play, and if memory serves, Frank recommends 60 hours or more. Given the difference in amplitude from DAC to Preamp, and from Preamp to Amplifier, do you guys think it might be worth swapping them out (rotating them) to help balance and perhaps accelerate the process?

Thanks in advance!

parabolic
parabolic OP
106 posts
 
I'm running a pair of Martin Logan reQuests which are 4ohms, so I figure  one of the loads that's 300W at 4Ohm should do nicely to mimic the speakers.  Thanks!
lak's avatar
Ag insider logo xs@2x
lak
4,537 posts
 
If you don't have a cable cooker, just sit back, relax, and enjoy the music as others have suggested.
parabolic OP
106 posts
 
@lak I think you missed the part where I wrote a couple times that I WORK FROM HOME and can't run speakers at volume for 200 hours.
lak's avatar
Ag insider logo xs@2x
lak
4,537 posts
 
@parabolic, if you are just breaking in interconnects and speaker cables you don't need any volume, just the signal. Are you trying to break in new speakers also?
I apologize if I missed something here?
Best regards...
gdnrbob
4,411 posts
 
Perhaps this is an Almarg question:
Does the cable need to be run at a high volume?
I mean that music is dynamic, having loud and soft passages.
Wouldn't running the system on a low volume when you need to work still accomplish the goal?
More to discover