I learned the hard way


I thought, (secretly hoped) some of you have had some hard luck stories to tell from your audio adventures that may have provided some benefit from sharing here so others may benefit..

I waited years until recently to try some Lyra SPT stylus treatment. The other weekend I opened the little top on the little bottle and turned it to an angle for application to it's little brush. The bottles' contents began spilling on my countertop. WTF! I then noticed/realized that there are two tops. The lower top came off when I unscrewed the smaller upper top. I just watched as $30 drained on to my countertop. I then made sure the lower top was extremely tight going forward. 

The good thing is, half a bottle will still last years.


128x128slaw
Some (not all) solid state amps that use a high-current design can self destruct due to internal oscillation when a speaker cable having a high capacitance is connected to them.

This is NOT an issue with TUBE amps to my knowledge

Ayre, Gryphon and NAIM are three amps that I know of that can be effected in this way

Regards
@williewonka ,

I wonder...? is this particular issue one that a reputable dealer would have knowledge of and then convey that to a potential buyer?
@slaw - I became aware of this issue because I have a NAIM amp and they promote the use of low capacitance cables as stated on their web site, probably because they have had to deal with the issue before.
Their NACA5 cables have pretty low capacitance values

The acquaintence that had the Ayre amps went on to borrow the Gryphon after the Ayre had the issue.

Unfortunately the Gryphon suffered the same fate - OUCH!

Neither Ayre or Gryphon had anything posted on their web sites at the time (over 2 years ago)

Even the technician that fixed the Gryphon had never heard of the issue. He was quite nervous when I hooked up my Van den Hul D352 cables - also very low capacitance - he even asked "are you sure" - YES was the reply - they presented no problems.

The cables that caused the issue were Cardas - I don’t recall the model - but a few of their cables do have quite high capacitance and they do publish the capacitance values, so perhaps they are at least aware of the possibility?

As for the Dealers - I have only found NAIM dealers I have dealt with do advise customers of this issue - probably in order to sell you the NACA5 cable :-).

Is this a case of "Buyer Beware" - or should the manufacturer "state the obvious"

I think it should be - ON THE BOX - at least in the manual - in BIG RED LETTERS!

It’s funny to think the manuals contain text that warn you of electric shock hazards - but not this issue?

It would be interesting to know if it is covered under related warranties?

All I know is - the Ayre and the Gryphon were in the $10k snack bracket - they should have a $0.50 sticker on the top stating the obvious

Regards - Steve
I learned twice that the stylus guard protects the stylus only when installed.  I also learned when buying a used cartridge the same rule aplies for a total of three stylus guard lessons.