JVC tt-101 repair

Did you resoldered all the eyelets by your own? 
This is what Dave adviced me to do too, but i never tried yet.

Anyway you have to run your turntable for some time to check it out. 

Yes I did. There are quite a few on the exposed side. You have to look under the wires. Dave recommends doing both sides and I’ll get to that. I ran it several hrs last night, switching between speeds, the pitch control, stopping & starting. Checked it again this mourning and holding steady.

What he says makes sense. The expansion and contraction of the board & connections. Basically the same as a cold solder joint.

gary7 

Think I asked this question on the "other" site 
you mentioned 115 volt so it is a QL-10 since the TT-101
was not produced in that voltage.

It is the QL-10 plinth, minus the 7045 tonearm. Has a QL-10 badge on the plinth. The lable on the TT-101 lists voltage as 120V.