DIY Power Cables Instead of Used

The Furutech FP S55N is a limited addition and is mostly sold out in the US and the DSP4 ( Not FPN4 , I was wrong) is like I said expensive. The TC series of cables would be good BUT whatever you do get the FI 50 NSF connectors they are more important then the cable. 

I had the Shunyata Sigmas,Alpha Nr and KC and after reading several post on Whatsbestforum where guys have sold off there Shunyata cables and replaced them with the Furutech' I tried them and sold mine as well. There that good.

The difference between the Shunyata and Furutech is in the layering of instruments and holographic soundstage with the Furutechs. The tonal balance, transparency, bass is the same. 

Technik ... you’re getting me excited here. … I’m a detail guy. Everything is important, but the first thing that captures my attention is hearing the detail, separation, layering. What then draws me in is focused placement of acoustics in a 3d soundstage,,,then I’m looking for the rest, until I’m in a euphoric dazed state on the recliner, soaking it all in. I’ll be reading heavily on your recommendations in the coming day or two...and once again...thank you!
>>> Rich

The cables well take 600 hrs to burn in but the Fi 50 NSF is closer to 700 hours, be patient and enjoy the burn in.

A few thoughts- you can make very good DIY power cords. I like shielded cable, and I use good quality plugs. Finish it off with some tech flex and shrink-wrap, and you have a nice power cord. You will save money but as already noted, resale value is zero. 

I've bought raw and remade Supra cable. I like the Supra cable, but I was underwhelmed with the ready made cable's termination quality. 

One cable I've found and like quite a bit is Cullen Cable Crossover series. Well priced and very good quality. 

Thanks Zavato. As a result of Technik’s comments, I started furutech reading which lead me into the "right" DIY. At this point I’m looking at, dependent on the component, a mix of power chords: furutech DIY, DHL DIY, and Pangea ready made. mixing it up based on my best educated guess, will enable me the opportunity to move cables around components to see where they perform best, as well.

Ive read up on Supra for about 2 yrs, and will be using their speaker wire for my rear and mid channels (I actually bought a piece 4 months ago to test, was very pleased, but have yet to follow thru with a full order) Im also getting ready to start comparing Supra power conditioner / surge protector to others, but initially theirs seems hard to beat anywhere near their price range. Reason I’m shying away from Supra power chords is that while they have a truly superior patented tinned copper process for low voltage applications, they are pretty new to the silver plating game, and their silver plating is pretty standard ... DHL seems to do that better for less.

For connectors I’m looking at Sonarquest, which is a direct furutech competitor out of Japan, but whose U.S. prices are notably lower, as they don’t have the furutech level marketing machine, and came to US market late...they seem to be going up in price, following on furutech coat tails, but are very well reviewed by pros amd individuals who have direct compared.

I will now add Cullen to my reading before I pull any triggers. Thank you again for your help on this, Zavato!