I would never pay more than what Kimber Kables go for. That's the limit of what I would pay. Bought a pair of Audioquest used on Ebay and still use them. buy Kimber in bulk or buy on sale. Bought a pair a couple years back from Audio Adviser on sale for couple hundred.
Help with advice for high end speaker cables for my system!
Hello I could use some advice with speaker cable choices. I am using a Marantz AV-7704 preamp, 2 Krell KAV250a amps, and a Krell KAV 250/A3 amp. The 3 amps are running to a pair of Martin Logan Request floor standing speakers, a Martin Logan Cinema center channel, and a pair of Martin Logan in ceiling surround speakers. 2 of the amps are bridged, one each dedicated to a Martin Logan stereo speaker, and the Krell 3 channel amp is running the center and rear surrounds. I listen to about 50% stereo music and 50% home theater. I could really use some help and advice with stereo speaker cables for the Martin Logan stereo speakers. All the high end shops in my area seem to have closed, so the ability to demo different cables is apparently not an option. I am considering Audioquest Oak cables, but really open to suggestions, especially if you have used similar components with good results. Thank you!!
- ...
- 34 posts total
Try Blue Jeans Cable. Custom made cables at a good price. https://www.bluejeanscable.com/store/speaker/index.htm |
| Post removed |
Another vote for the Duelund diy route - I tried this wire based on a lot of comments on this forum and others - ended up selling a 1500.00 set of XLO signature speaker cables - and couldn’t be happier - have since built some IC’s and replaced Kimber cables between my phono stage and pre amp - again pleasantly impressed - for speaker wires - just use bare wire - no connectors - This wire is the real deal and a no brained for speaker wire ( because it’s so simple - no ends - no soldering - sound fantastic after a few weeks - found I had to turn my sub volume down as I was getting much better bass response from my mains |
- 34 posts total