2. analog
  3. 138237-4374

Home grown turntable platform/base?

I picked up a used Pro-Ject Debut Carbon turntable for the family room. We are not big into vinyl, mostly listen to digital, but my 16yo daughter has shown an interest in getting some records. I’m getting excited about her interest in vinyl and audio. What is a good platform material to use? Wood? Granite? Should I add sorbothane and/or spikes underneath? I’m not looking to spend a lot but feel I should have some decent isolation for it. The turntable currently sits on a hollow shelf. It’s where it has to be so I need to make this work.

Thanks for any input.
asahitoro
asahitoro OP
244 posts
 
Thanks again for the excellent replies everyone,

I’ve been looking at maple blocks on Amazon including the Butcher Block Acoustics one mentioned. Prices seem reasonable and I already have some spikes. What is too thin for the block to be effective enough? I’m looking at 1.75" ones and the 3" BBA one. Is Maple the main choice as I see Walnut for more?
noromance's avatar
noromance
10,020 posts
 
Go as thick as you can on the wood. Not all butcher block is the same. Don't write off granite so easily, especially if you like detail retrieval, air, and tight clean bass. You could sit the granite on felt pads.
bdp24's avatar
bdp24
10,008 posts
 
asahitoro, even if you go with maple or butcher block, consider getting two pieces and placing a thin sheet of constrained layer damping of your choice between them. That will mitigate the resonance found in all materials, including wood. Actually, especially wood---that's why they make drums and guitars out of it! Another thing to do is put the grain of the wood in the two pieces 90 degrees opposed to each other; one with the grain front-to-back, the other side-to-side. That will increase the stiffness of the assembled shelf.
asahitoro OP
244 posts
 
Thanks again,

I'm not trying to be cheap but I only have $275 into the turntable so I don't want to over do it. I'm sure there's point of diminishing gains for the the Pro-Ject and what it's capable of.  I'm thinking $100 max on this platform.  I can get a 3" BBA maple block for under that. I already have spikes and it comes with 4 'Anti Vibration Pads' to try as well. I can get a 1.75" thick piece of walnut from them for the same as a 3" piece of maple. Stick with 3" of maple?
bdp24's avatar
bdp24
10,008 posts
 
A sheet of 3/4"/19mm 13-ply Baltic Birch plywood (it is available in both 4’ x 6’ and 5’ x 5’ sheets) will cost you only $50 or so. Cut two pieces to size and glue them together. MUCH stiffer that the twice-as-thick 3" thick piece of maple, and more non-resonant. While some people like the sonic signature of Maple, remember, it is stiffness and a lack of a sonic signature we want in a support platform, not a pleasing coloration. IMO, of course.
More to discover