2. amps-preamps
  3. 138390-118712

McIntosh Jumper Plugs alternative

Hi there -

Like a lot of us out there, I’ve always wanted a McIntosh amp and yesterday that long dream finally came true!

A new MA5200 showed up on the doorstep yesterday to drive my dads old ProAc D25s and like a kid on Christmas I couldn’t wait to get started. Getting everything setup and wired I fire up the turntable and there’s no audio in the left channel... I double and triple check that all my wiring was correct and I couldn’t figure out why. 

With a fresh mind and a fresh set of eyes I check it again today and there it is... I’m missing one of the two jumper plugs!! No wonder there’s no audio...

Ive contacted the dealer to get an extra plug but wanted to see check if there’s another solution? 

Could I just get two short male/male RCA cables or would that not be “safe” or suggested? I’m probably extra sensitive and mindful considering this is my first Mc!

Any thoughts or insights would be much appreciated!
scandiaudio
yogiboy's avatar
yogiboy
5,664 posts
 
That would be fine!
stereo5's avatar
stereo5
6,385 posts
 
@beyondarkness...…………………………………….

I have the McIntosh MA6600 integrated and I replaced the cheap jumpers with the Audioquest jumper cables which cost 30.00. A great investment and a noticible difference in the sound for the better.
scandiaudio OP
1 posts
 
@yogiboy thank you! A pair of RCA cables did indeed to the trick. 

@stereo5 thanks for the insight! I have to look into that. For $30 it’s a small investment so little to no downside it sounds like. 
More to discover