Adding watage alone with any speakers only means they should play somewhat louder with lower distortion. That is usually a good thing in regards to bass, especially at higher volume, but does not mean anything necessarily in terms of better frequency response at lower frequencies. Two similar wattage amps will likely perform differently at the lowest frequencies. A lot has to do with the impedance load of the speakers and the amps ability to perform accordingly, especially at lower frequencies. In general, smaller speakers that can extend lower will require a more robust power amp to deliver the current needed into lower impedance loads that typically occur at lower frequencies in order to have good low end frequency response. Of course this is just a general pattern, YMMV depending on amp, speakers, room acoustics, etc.
Ohm Walsh Micro Talls: who's actually heard 'em?
Hi,
I'd love to hear the impressions of people who've actually spent some time with these speakers to share their sense of their plusses and minuses. Mapman here on Audiogon is a big fan, and has shared lots on them, but I'm wondering who else might be familiar with them.
I'd love to hear the impressions of people who've actually spent some time with these speakers to share their sense of their plusses and minuses. Mapman here on Audiogon is a big fan, and has shared lots on them, but I'm wondering who else might be familiar with them.
- ...
- 2916 posts total
- 2916 posts total