Grado/Rega Hum

Fix the problem at the source. It is most likely due to a grounding or shielding issue. The RP3 being belt-driven is unlikely to be radiating enough EMI to bother the Grado, even though Grado is notorious for poor EMI rejection. First, determine when the hum goes away. If it is present only with the motor on, check the routing of motor power wiring to ensure it’s not parallel to the interconnect or tonearm wire at any point. If the hum is present with the interconnect detached from the tonearm, look at the phono preamp connection to the preamplifier. If the phono preamp power cord is not polarized, try reversing the plug polarity in the receptacle. If the hum is present with the phono preamp connected, but not powered on, try running a ground lead from your preamplifier to the phono preamp. Bottom line: you need to use process of elimination to narrow down the source of hum until you eliminate the cause. 

Sleepwalker,

 I have an external power source to the turntable (PSU).  The Rega has a non-detachable power cord.  Also, my preamp has a built-in phono component (Conrad-Johnson PV-11.)

Now that I’ve got a subwoofer component in my system, I hear the hum even at low volume, but only when I get close to the speakers. Otherwise, I don’t know it’s there; that's what you said.

"Otherwise you don't even know it's there".


You do not have a "hum hum" problem, but one that goes with that combination of components; that you only hear when you get close to the speakers; that you did not hear before you got the "subwoofer".

You can either change components, enjoy the music, or spend the rest of your life trying to fix a problem that you didn't even know you had until you got the subwoofer.

Orpheus10,

I tend to agree!

Sometimes it's best to just leave s--t alone.