Requirements for Moving Coil setup

You need a phono preamp with MC capability whose inputs you can plug your turntable/cartridge into and then that same phono preamp's outputs into a line-in input on your Bryston 2B preamp.

Grado > new MM phono amp > Bryston 2B-MC preamp line input.

New MC > Bryston 2B-MC phono input (set rear switch to MC mode).

Most moving coil cartridges are low compliance, and are meant to be used on a low compliance tonearm. I doubt the JVC would be equipped with a low compliance tonearm. A more suitable MM cartridge for the JVC (if it’s a direct drive) would be a shielded body cartridge like those from Audio-Technica and Ortofon. My experience with the Audio-Technica VM540ML (line Contact stylus) is very good on Technics turntables that have mid-high compliance tonearms. Not sure about the BIC, but if it has a low compliance arm, it would probably be more suitable for a MC cartridge. Keep in mind that you will need to spend at least double what you’d pay for a good MM cartridge just to have sound quality on par, then you must also factor in a new MM phono stage for the remaining MM.  

I have a Denon 103 mc in use on a Grace 707 arm. And a 103R on the Pioneer PLX1000's medium-mass arm. Both sound fine! I have yet to try out some of my other mc cartridges on my two heavier Fidelity Research arms - an FR29 and an FR54. 

sleepwalker6510-27-2018 8:43pm

Most moving coil cartridges are low compliance, and are meant to be used on a low compliance tonearm. I doubt the JVC would be equipped with a low compliance tonearm ...  Technics turntables that have mid-high compliance tonearms. Not sure about the BIC, but if it has a low compliance arm, it would probably be more suitable ...

You're confused - there's really no such thing as a "low compliance tonearm." It's a pickup arm's mass and damping that determine its suitability for a specific phono pickup compliance. Believe me, you don't want a compliant pickup arm.