Thiel Owners

Thanks Tom & Beetlemania :-)

For sure it's the PCB version, resistors are equal but there are no marks on the coil's, do you guy's know the value of the changed 0,72mH coil on the PCB version? I wil also look for the other parts that you reported.

Can't find a Mills 4ohm resistor in Europe that's why I changed them to a parallel 4R7 and 27R resistor with a total result of 4R003

See photo,
https://www1.picturepush.com/photo/a/16063392/1024/Thiel-CS-2.4/20181101-192450.jpg 

Happy Friday- ALL.

@holco Your PCBs look a bit different than mine in that you have different brand caps. Mine are CYCs other than the Clarity SAs in the coax feed; yours might be Solen? Regardless, your cap quality looks superior to mine other than those Claritys. My CYCs are MKTs whereas your caps are labelled as MPTs. Also, the coils appear to be higher quality in that they are more tightly wound. Finally, the board itself doesn’t appear to have any labels.
Here is the backstory on the coils. When I upgraded my resistors, I noticed the PCB had the parts’ values printed on the boards. I wrote to Tom Thiel:

I forgot to mention an interesting artifact I noticed when I replaced the resistors yesterday. The PCBs have all values labeled. On the woofer board, instead of inductor values 0.72, 0.3 and 0.06 mH per schematic and layout, it has 0.65, 0.22, and 0.06. On the coax board, instead of 6 and 0.15, it has 5.78 and 0.13

Tom investigated this and discovered the PCBs were sourced from FST whereas Thiel traditionally made everything in house using point-to-point. Apparently, the modified values are to compensate for the PCB environment. But maybe it’s even more complicated given that you have a different generation PCB than me? My SEs are among the last built. The seller claimed they were built in 2012. I’m guessing your 2.4s are older. Perhaps Tom can add his thoughts about your coil values.
My rebuild will be point-to-point on Masonite and I’m going to use the coil values as indicated on the layout and schematic (I plan to build completely new boards other than I will reuse the MRA-12s). If you are keeping your PCB, you might need to use the modified coil values if upgrading.

pwhinson

I had purchased only the spikes and not the outrigger support stands
from Coherent Source ,
I used the new spikes with the original locking nuts .
Now the spikes penetrate the carpet
The outrigger stands look great but cost to much for me .

Rob

tomthiel - Larry Staples rings a bell.  If he is on this thread then let me say "Hello, Larry" as well.  As to it being a forming experience it was.  I bought the 3.5's as much on that Kentucky experience as the dealer's showroom, since he had pulled the speakers at the time I stumbled across them.  I have also liked Spica's and Vandersteins and so I guess my ears were latently attuned to phase coherence.  At least I believe the lack of same messes up some speakers that should sound better than they do.

Jafant - Glad you enjoyed the story.  I've got a few more audio stories to tell as well, but this is not the thread for those.