Integrated Amp to match with Magico A3


Have just ordered a pair of Magico A3, and looking for integrated amplifier to pair with it. As I heard once which had a very disappointing result to pair with Gryphon 300 in a local Hifi show in Hong Kong. Reallly looking for recommendations on matching amplifier. Planned to get a Marantz PM-10, but worried that the single box may not be powerful enough to push the A3. On the other side, some said Hegel H360 with 4000+ damping factor may suit even better.

thank you in advance
eldonfung

freesole OP
56 posts11-17-2018 9:26pmBrought my LM 805ia to test on the Magico A3’s today and wow. It sounded (to my ears) so much better than with the Hegel gear that the Magico’s were being demo’d with. No issues with driving the A3’s on the 805ia at all. Even the shop owner acknowledged that he was a bit taken back because he did not expect the pairing to sound so good. He remarked at how he didn’t think the A3’s sounded as good with any other amp pairing he had in store and proceeded to ask where I got my Line Magnetic from. More dynamic and warmth - both were very present characteristics that I heard today. Also heard some surprisingly deep, low end bass that I don’t know that I expected with this pairing - considering the specs on paper recommended 50W minimum to drive these speakers. I would be very happy with this combo.

Tomorrow, I test the Daedalus speakers. Hoping to audition both the Argos V2 and the Athena V2.


He is looking for the speaker to mate with Line Magnetic 805ia SET amp and got very happy with Magico A3 yesterday.
@jsqt " At lower volumes when I am listening at night, the L-509X loses a little bit of its sparkle and depth, and I’ve found I can replace this by using my vintage Luxman CL40 as a preamp, and using the L-509X’s "Separate" setting (basically HT Bypass)."

I was following along some of your post to learn more about the 509x. I saw the statement above sometime back and it stuck as being a negative on the 509x at low volumes. You seem to contradict that statement with your post on this thread. Can you elaborate some more on the sound of the 509x at low volumes? Does the sound have most of the freq response to it or do you lose something when the volume is turned down. How about the imaging? I notice that in my bedroom integrated (Peachtree Nova 150 the imaging gets a little off at the lowest volumes.)

The Mark Levinson 585 was one amp that I have heard that was able to keep the freq  response even at low volumes. Another integrated I have not heard yet, the Lyngdorf 3400 is also supposed to be great at low volumes.
I would try the Aesthetix MIMAS integrated

anyone who says they know more than 99% of everyone else should apply for work with Dumpsterfire...
ciao
Audioquest
Welcome back melbyguy1
i always think of you when rebalancing the asset allocations in my system, even named my reference system after your “ garbage in, garbage out quote”
i am mellower now.... might be time to drop that ......