2. amps-preamps
  3. 132245-34152

Aragon 8008x5 with Vandersteen 2w

Hello everyone, 
     I know this is a long shot but is anyone using the above combination. I am attempting to find the correct balanced crossover. I have 20K RCA, 150K balanced, these do not sound good. I do have the WX2 box but believe it is defective. I have downloaded the Vandertones and am using a multi-meter to check AC voltage at the speaker. None of that matters if I do not have various capacitors to try. 

So.... since I do not know the correct input impedance for this amp, does anyone have one they are using successfully with a 2w series sub-woofer?

PS, the advertised spec I found for the amplifier is 22K single ended. The 20K single ended crossover does not sound or measure correctly. I believe the impedance for the 8008x5 may be different from an 8008. Speakers are Vandersteen 2ci.

Thanks in advance!       
jwmorris
gdnrbob
4,444 posts
 
Those Sub 3's have me drooling. 
@tomic601 ,
I doubt they will get you evicted, but just provide that bit of oompf that the Treo's can't deliver due to size. Even my 2wq's are not producing notes that would consider offensive to other dwellers- And, yes, I went in the basement, as well as the second floor. But, to be fair, I really don't crank it up- Just normal listening levels.
Bob
tomic601's avatar
tomic601
12,911 posts
 
Well.... this was of course so point of debate and applied science during the run up to remodel of the condo and selecting speakers... having Model 7 and also not being a very loud listener can inform with real data just what real 30 cycle performance at 75 dB looks like a floor below.
i put in a double layer of cork / magic stuff over the concrete slap and under the engineered hardwood floor.
i know the neighbor below and her unit is for sale ( and has been )
but as you say the siren song of the 3 is strong...
i think I know a guy with a loaner...

i have my Audiotools RTA
i love real data....
jwmorris OP
46 posts
 
I apologize for the late response. I usually do not try to type a response on my phone, the computer is so much easier. 

@gdnrbob 
The crossover is really nothing special, a capacitor is soldered in place between the two signal carrying wires. The ground wire is extended as needed. For now I simply used heat shrink tubing to protect against the wires shorting together. Later I will make a more secure enclosure.    


jwmorris OP
46 posts
 
I am sure the Sub three sounds amazing. I would love an opportunity to hear one. In the meantime I will enjoy what I have and keep an eye open for upgrade opportunities. 
More to discover