Does impedance of a speaker change when one bi-amps?


I'm fairly new to the audiophile arena and i have seen this question asked before, but not answered.
rickytickytwo
Beside the advantage of a bi-amped speaker presenting an impedance of less variation to each of the two power amps than one amp sees from a non-bi-amped speaker, the speaker’s drivers are also connected directly to the amps, not to the speaker’s internal crossover components. Bi-amping is usually (and best) done with an external electronic x/o before the two amps.
Beside the advantage of a bi-amped speaker presenting an impedance of less variation to each of the two power amps than one amp sees from a non-bi-amped speaker

Sorry @BDP24 this is not really true as you put it. See from my blog post and any simulation, the min to max impedance is MUCH greater with a split crossover.

The overall current load however is always decreased. This may help the power supplies stiffen up.

While active bi-amping is good, it’s also complicated. It’s much easier to get top of the line parts and design in a passive. Do what you like, but it’s no free lunch. It is however preferred in pro environments as the dynamic range and amplifier to output is improved. Need less total watts for the same SPL.

Best,
E
The impedance curve of the speaker is separated into two pieces: high and low. The amplifiers only get one of those respective load curves. With most bi-amp-able speakers, the low cutoff feeding the midrange and tweeter is still in the circuit. Likewise, the high-cutoff still rolls off the highs hitting the woofer. Put both together as one load to one amplifier, and additional interactions affect sound quality, usually for the worse. Bi-amping worked very well for my system, but ymmv. 
I have bi amped several systems and never heard a difference that would justify the additional amp. Bi wire, same thing. I did hear a difference with an active 3 way system with an external crossover though. It was a Linn isobarik Brik system. I also copied the the Linn system with 3 Bryston LP2's and a Behringer 3 way analogue crossover. It was awsome. And cool to talk about. :)
@pkvintage

 I have bi amped several systems and never heard a difference that would justify the additional amp. Bi wire, same thing. I did hear a difference with an active 3 way system with an external crossover though. It was a Linn isobarik Brik system. I also copied the the Linn system with 3 Bryston LP2's and a Behringer 3 way analogue crossover. It was awsome. And cool to talk about. :)

Kudos for going the extra mile.I have been promoting multiamping here for years. I designed the Beveridge RM3 crossover which allows easy  changes and has level controls for both outputs. It is all discrete analog. 

 Most here haven't the nerve to so what we have done so they just bad mouth what we are doing. They dont understand the advantage of removing the un-wanted signal Before the amplifier rather than after. They would rather waste their money on expensive crossover components for a less than optimum solution. 

Someting to think about. If the bass voltage is still present in the treble amplifier then the IM it creates is going to be the same. 

Keep at it man, I will support you.