Running Benchmark AHB2 in bridged mode and 4 Ohm Speaker

ramtubes
It appears you may be confusing gain with power as many do.

He is, by me too.

douglas_schroeder

The amp is FAR superior sounding in bridged mode regardless of the speakers used, efficient or less efficient.

I ask again, then why sell it in stereo mode if it’s so hobbled in stereo mode???
You should then be suggesting that no one buy it for stereo mode listening there are far better offerings.

douglas_schroeder
I have said several times previously that there is NO sonic degradation in bridged mode, nor distortion associated with running the amp full out.

This is a furphy, I didn’t ask that half a page back, I asked a simple question of amp sound quality driving the Kingsound III it was ignored. I present it again.

"How did one stereo amp sound to a level it was totally comfortable at.
Then the bridged ones at the same level?"
"To gauge which sounded better."
"NOT WHICH COULD GO LOUDER!"

I think it all needs "paralleled interconnects attached to each channel", that should fix the problem/s.


Cheers George

@georgehifi 

I think Benchmark has done an excellent job of convincing everyone to buy two. Hail to marketing. All those who follow can do is quote the party line. We will never get them to understand. 

ramtubes
I think Benchmark has done an excellent job of convincing everyone to buy two.

Got a feeling there’s a couple of latent shills helping out too.

Cheers George

@georgehifi  Got a feeling there’s a couple of latent shills helping out too

Likely indeed. The marketing guy did step in at one point. We really gave it a good shot.

Check out this thread claiming there is no RMS power.

https://forum.audiogon.com/discussions/rms-power#1665330

 Read the banner at the top of the Wicki page and check out the references given below. especially #8. Then read all the compliants on the talk page. Im writing someting up.

https://en.wikipedia.org/wiki/Audio_power  

@kijanki 

to me

From Wikipedia "Audio Power"

As described above, the term average power refers to the average value of the instantaneous power waveform over time. As this is typically derived from the root mean square (RMS) of the sine wave voltage,[6] it is often referred to as "RMS power" or "watts RMS", but this is incorrect: it is not the RMS value of the power waveform (which would be a larger, but meaningless, number).[7][8][9][10] (The erroneous term "watts RMS" is actually used in CE regulations.[11]) This is also referred to as the nominal value, there being a regulatory requirement to use it.

Al, leave it (he is not going to get it). . 

@kijanki  Feedback lowers output impedance. You cannot make exact doubling of the power if DF=10.

Of course feedback lowers output impedance. However that has nothing do to with output power at clipping. Its not like there is some resistor in there.

I assume you are adjusting the input level as you explore these power output levels. 

What is this EXACT doubling of power all about.. Why does it have to be exact?