Pass labs xa25 amp and BW 804 d3?

Thanks for your very informative posts, Kosst. I’ve learned some things from them about my own XA25 that I didn’t know previously.

Regarding the references in one of your posts to "average volume," others should keep in mind that what matters with respect to an amp’s maximum power capability is of course the maximum volume levels that are reached on the recordings that are listened to, not the average level. And the relation between the maximum and average volume levels will vary dramatically among different recordings, depending on both the music and on how much dynamic compression has been applied in their engineering.

For example, some classical orchestral recordings that have been engineered with minimal or no dynamic compression may reach brief dynamic peaks that are 30 db or more greater than the average level of the recording. Which in turn means that around 1,000 times as much power will be required to reproduce those brief peaks compared with the amount of power required to reproduce the average level of the recording. While many and perhaps the majority of pop and rock recordings are compressed to a dynamic range of less than 10 db, which will require less than 10 times as much power for peaks than for the average level.

Thanks again. Best regards,
-- Al

Thanks so much everyone.The core values of these forums are to help, instruct, inform and intrigue. The amount of knowledge and experience that has been directed my way makes decisions a little less stressful. My gut says pass xa25. Thanks again.

@almarg Didn't know you'd switched to this amplifier. Are you subbing out with the VAC, or have you switched completely to the XA-25?

@Cal3713, I’ve sold the VAC Renaissance 70/70 MkIII amplifier and I’m using the XA25 exclusively. I decided to purchase the XA25 a few months ago while the VAC was back at the factory for a minor repair, motivated mainly by all of the glowing reviews I’ve seen of the XA25. While also taking into account the sterling reputations of Pass Labs and the dealer from whom I purchased the amp (Reno HiFi) for customer service and support, as well as Pass Labs’ reputation for building products that tend to be reliable and trouble-free over the long-term. Regarding the reviews, I found Teajay’s (Terry London’s) review to be especially accurate in its characterization of the amp’s sonics, at least with my easy to drive Daedalus Ulysses speakers.

Following are some comments about the XA25 that I had occasion to post a few months ago in a thread that was mainly on a different subject:

It comes amazingly close to the VAC with respect to dimensionality, imaging, liquidity, and other traditional fortes of high quality tube amps. It’s a bit less rich sounding than the VAC, but I interpret that as an increase in accuracy, which is fine as far as I am concerned.

There are also some non-sonic factors favoring the XA25, including the likelihood of greater reliability in the years ahead considering the age of the VAC; the fact that even though both amps operate in class A the XA25 puts only 240 watts of heat into the room compared to what I believe is upwards of 700 watts for the VAC; and the cost that would be involved in re-tubing eight 300Bs if and when that were to become necessary.

This is the first time I’ve had a high quality solid state amp in my system in about 25 years, and I believe I’ve picked the right time and the right model with which to do so again.

On another note, happy holidays to you and yours, and all best wishes for 2019!

-- Al