take the crossover out and lower the non polarized cap to the tweeter, if its 1.0uf drop it in half.
What is the best way to tame a slightly bright speaker?
I know the answer is get a speaker that isn't bright, but I've got a pair of TAD Evolution Ones that I like quite a bit except that the magnesium midrange and beryllium tweeter are just a little bright for me. I'm driving them with a D'Agostino Classic Stereo, which I needed to drive my old speakers but I don't need all that muscle for the TADs (89db sensitivity, 4 ohm impedance {doesn't drop below 4 ohms}) recommended power 50 to 250 watts.
I'd like to get an amp that does voices especially well. I know somebody posted recently that a subwoofer solved his brightness problem and I may look into that at some point. Any and all suggestions are welcome.
I'd like to get an amp that does voices especially well. I know somebody posted recently that a subwoofer solved his brightness problem and I may look into that at some point. Any and all suggestions are welcome.
- ...
- 74 posts total
If you’re looking for an excuse to spend money, you have been given many. But my immediate instinct without a second’s hesitation is, “Oh! Well, just toe them out!” If you are receiving too much energy from the mids and the energy increases with frequency, toeing them out is a perfect fit. Directionality increases with frequency, too. So toeing out just a little bit has the most pronounced effect on the highest frequencies, less on mid, and it goes drops off rapidly from there. |
Toeing out sounds fine. Not to harp on this, but simple attenuation is the right solution. Looking at the crossover, a resistor change looks extremely easy to do cause it appears accessible from the base and detachable with screws. https://static1.squarespace.com/static/55f2f41ee4b0ef7e0849e07a/t/56217563e4b0fd57269f160f/154372792... The tweeter section is at the top and you’d want to try higher values for the series resistor (before the coil!) to the tweeter’s positive input. Mills MRA is very cheap. You could also even just use alligator clips to parallel on incremental values to the existing resistor to determine the best overall padding. http://www.sengpielaudio.com/calculator-Lpad.htm |
- 74 posts total