What is the best way to add a 5:1 system

Thanx much for the tips. It will be a while before this happens, but thought I would get a vision for it should look like. Sounds like I will need a processor and another amp with 3 channels, or would it be easier to have one amp for the 5:1 and the 402 strictly stereo? That is how most of my time is spent.

It sure is nice to be back into new listening. Am actually keeping all of my previous system for another location. Can't bear to part with it!

Jeff,

I'm attracted to the notion of an Integra 9.9 processor for surround SACD via HDMI and newer codecs for films, but I'd still like to use my Proceed PAV/PDSD for stereo music. (Maybe the PDSD would be redundant.) Just to be explicit, are you saying I could take the pre-outs from the 9.9 to any unused input of the PAV? I assume the PAV (or PDSD) XLR outputs would still go to the Proceed Amp 2 for the front LR speakers, but the 9.9 XLR outputs would go to the Amp 3 for the center and surround speakers. Am I understanding you correctly?

db

db . . . it will work fine. I have a PAV that I use for Stereo (amazing stereo pre) and I moved it to my HT, using my Lexicon MC-1 for 5.1 input to the PAV. It worked fine, but because of ventilation issues in my HT rack it over heated so I had to move it to another system.

Thanx much for the tips. It will be a while before this happens, but thought I would get a vision for it should look like. Sounds like I will need a processor and another amp with 3 channels, or would it be easier to have one amp for the 5:1 and the 402 strictly stereo? That is how most of my time is spent.

I would go with your best/most favored amp for stereo and add another 3 channels of amplification for the surround. depending on your configuration you can get a 3 channel amp for the ctr/rears, or if you're like me and like to use short speaker cables, get a mono amp for the center (somewhat matched to your 402), and a pair of mono's or a stereo amp for the rears. If you get a 3 channel amp you'll need long speaker cable runs to your rear channels. Of course alternately you need long interconnect run.

The problem with getting a 5 channel amp for 5.1 is you need to swap cables, which is a big pain.

Hey Bd,

Good suggestion. I had thought about the cable switch concern and was wondering, since I already have a high power selector box for selecting combinations of front, rear and an outdoor set, if there is a way set up something to select the current set up or a 5:1 system with 5 channel amp that could be arranged w/o the cable swap. Essentially two discrete systems sharing selected speakers with selector boxes instead of swapping cables, which I agree is a real pain!

I figure if not, then a 3 channel amp plus the MC 402 would work, but I do listen to much of my music with front and rear and wish to keep that ability.

regards,
rr