But for $1500 you can purchase Altec model 19 in good condition. Add fostex t900a tweeters a few parts adds about $1100 more, performance of this combos hard to beat under 10k no mater what you buy. And can be tweaked to be even better for not much outlay or skills. Heck most guys who complain about DIY a horn kit or adding a super tweeter easily can assemble there computers or modern furniture that seems be most DIY kit in itself.
Why not horns?
I've owned a lot of speakers over the years but I have never experienced anything like the midrange reproduction from my horns. With a frequency response of 300 Hz. up to 14 Khz. from a single distortionless driver, it seems like a no-brainer that everyone would want this performance. Why don't you use horns?
- ...
- 992 posts total
To Johnk or any other person knowledgeable about Altecs - could someone briefly describe the differences between the Altec model 19 and the A7 Voice of the Theater? I am very familiar with the latter, as my uncle owns a pair, but I have never heard the former, and I keep hearing a whole lot of Altec fans saying they are the best. Why? |
Learsfool, I don't have first-hand experience with the A7, but it seems to me that there might be a step-down in response below the frequency were the short horn in front of the woofer un-loads, such that in the bass region the response might normally be down a few dB relative to the midrange and above. This may be compensated for in the crossover, or it could be offset by boundary reinforcement with appropriate placement. Lacking that short horn in front of the woofer, the Model 19 would probably be a bit lower in overall efficiency but would not have a potential step-down between the midrange and bass region. Perhaps the primary innovation of the Model 19 was moving the crossover frequency up to 1200 Hz. This seems rather counter-intuitive, but what it did was allow pattern-matching in the crossover region. At 1200 Hz the woofer's pattern had narrowed sufficiently to match that of the horn, so there was no discontinuity in the off-axis response. The "manta ray" horn had constant directivity in the horizontal plane above the crossover point. These are worthwhile characterisics because in many listening situations the off-axis response strongly influences or even dominates the perceived tonal balance, though I think horn design has advanced since then. Wayne Parham, Earl Geddes, and yours truly embrace constant directivity and pattern-matching in the crossover region. A few years after the Model 19 was introduced, JBL designed a studio monitor, the Model 4430, with strong emphasis on pattern-matching in the crossover region as well as constant-directivity above the crossover region. I would not be surprised if the Model 19 was one of their primary inspirations. While the horn geometry is quite a bit different, the basic concept is similar to that of the Model 19. Here's a link to an Audio Engineering Society paper written by the designers of this speaker: The landmark JBL Model 4430 studio monitor Duke |
- 992 posts total