A comparison between two DACs, one R-2R, the other ES 9038-based.
This is an item from the FWIW Department, I guess.
Recently I set up an A/B comparison between a Denafrips Pontus and an OPPO Sonica…. Both DACs fed from a Nuprime CDT-8, via the XLR inputs on the same preamp, and everything else constant through the two signal paths to the speakers.
The result when I repeatedly toggled back and forth from the preamp’s input one [Denafrips] to its input two [OPPO]?---- To my surprise [and disappointment], the sounds from the two DACs were utterly indistinguishable, across all kinds of music, after repeated trials … impossible to tell apart… impossible.
The moral of the story? I don’t really know, but it does suggest to me that those who say that DACs of comparable quality cannot be told apart just might have a point.
I bought both the Pontus and the Sonica because I thought that it would be nice to have on hand DACs of “different flavours,” one based on an R-2R ladder, the other based on a delta-sigma chip.
I did want the expected difference to be real… just for the fun of it… else why spend the extra money? So, my “confirmation bias” was, if anything, stacked in favour of there being a detectable difference.
However, the results of a reasonably well controlled comparison [sadly?] did not bear out that expectation. Differently based DACs, 2-R2 vs delta-sigma, may not offer such different flavours as many suggest. Is that claim all much ado about nothing?
Thoughts from members of the Forum?
Folks sell digital data stream reclockers to reduce or remove jitter. Try one for the digital stream output from your NuPrime CDT-8 Pro transport. That might help clarify how well the two DACs perform when compared. Try shooting a pm to Steve Nugent of Emperical Audio. His member name here is audioengr. https://www.empiricalaudio.com |
zimmerma regarding having the volumes match its not just about having the volume know in the same setting. Dacs can have different outputs one Dac say an 2v output another a 3v in that case the 3v output will sound louder at the same volume setting. You really need a db meter to verify the loudness match. Also I personally would suggest, if you can, changing up your methodology. What is often more helpful for me is putting a component in my system and listening to it at length weeks or even months. Then switching components listening some more at length and finally going back again. More subtle differences often become more apparent over time. As always just my opinion YMMV. |
To celander:
To jond:
|
