2. amps-preamps
  3. 146422-7302

Finding the right tube preamp (input values) for Mccormack DNA

Forgive me but how do I determine the input sensitivity on any particular tube preamp? 

I have tried to figure it out some manufactures are easy and label it but some have a lot of values and with my limited knowledge of values and current specs I find it hard to figure out which is a good match.

I have a Mccormack DNA-1 Deluxe and am looking to add a tube pre. I have seen the likes of Audible Illusions, Conrad Johnson, BAT, and others who are good matches but I would like to possibly see about modern gear for a good match. Like Jolida, Rogue and Odyssey to name a few. 

What are the specs I am looking for to see if they are a good match? I have read the Mccormack has input value of 10v.

Thanks,


db
photodusty
photodusty OP
100 posts
 
I should add I am looking for Preamps under $1500. I also have NHT 3.3 speakers.

db
yogiboy's avatar
yogiboy
5,656 posts
 
The input sensitivity of the DNA-1 is 1.2 volts and input impedance of 100k ohms. Any preamp should drive that amp with no problem!!
gdnrbob
4,444 posts
 
@yogiboy ,
+1
When in doubt, call Steve at SMcAudio. I think they will confirm Yogiboy's advice.
FWIW, a used Atma Sphere UV-1 would be a nice match.

B
photodusty OP
100 posts
 
Thanks @yogiboy ....I have read that some tube preamps would have too much gain for the Mccormacks due to the high input...... hmmm

@gdnrbob I will be in contact with him this week. Thanks,


db
lowrider57's avatar
lowrider57
5,417 posts
 
You must take the preamp gain into consideration. In most cases it's not an issue, but CJ preamps have high gain. Find the gain of the actual preamp you're interested in and ask Steve McCormick.

More to discover