Might be best to discuss the specific speakers you are thinking about. People can give you specific recommendations.
Best,
E
Amplifier design parameters required for a good match for high (16+) ohm speakers?
Most SS amp will output half the wattage @16ohm than @8ohm, you
need to check if a amp has enough output power to drive the 16ohm speaker to
desired
loudness/SPL. https://www.crownaudio.com/how-much-amplifier-power |
As long as the amplifier has enough power that it won’t be clipping into the 16 ohm load, it should work just fine, unless there is some other mis-match going on. I have made speakers that are user-configurable as either a 4 ohm load or a 16 ohm load. As long as the amps weren’t pushed into clipping, to the best of my knowledge all of my customers who tried it both ways preferred the 16 ohm configuration. I have been told by multiple amplifier designers that distortion is lower into a high impedance load. At least one amplifier designer, Ralph Karsten of Atma-Sphere, recommends high impedance speakers particularly for his lower-powered OTL (output transformer-less) amps, which unlike solid state amps actually make MORE power into a 16-ohm load. If you haven’t already, I suggest taking a look at his amps. (Disclaimer: I’m a dealer for Ralph, and have been making speakers with his amps specifically in mind for 14 years.) Duke |