subwoofer question


hi everyone, i have a chance to buy 2 m&k mx-150thx(mark I) subs for $900 shipped.
first off is this a good deal or am i over paying.
next, because these subs are old (10-15 years), can they compete with the new subs which use better technology.
i only use my system for home theater.
my room is 14x12.
will these subs be great for my room or should i get one really great "USED" sub like a jl fathom, or velodyne dd series, svs, etc.

thanks so much
nineballg
Marty,

I have a Onkyo 905 for HT duty so it has Audyssey.
For HT I have the sub connected from the sub out on the Reciever, but for 2ch I have it from the speaker so the reciever is not involved.

I guess for HT the Audyssey will be used but I still think the Room corrector in the JL sub might be superior to the Onkyo?

I use a 10" sub because I want the speed in the base to match the speakers however Im still contemplating adding a second sub....
Perrew,

I'd advise you to sift through the subwoofer threads on this forum. There's a boatload of info that might (or might not) change your mind about a lot of things (including the relative speed of smaller subwoofer drivers). In particular, Bob Reynolds, Shadorne, Drew Eckhard and KR4 (Kal) have offered good insights.

As to Audyssey style DRC for 2 channel music reproduction, that's a bit controversial. Some love it - some hate it - and some (me, for instance) love it with certain reservations. In your shoes, I'd try it both ways to see which sounds better. I'm pretty certain the bass will sound better with Audyssey, but only you can decide whether the price you pay higher up in frequency is acceptable - or even if there's any price at all. See if it's really audible to you, then decide.

Marty
Marty,

I should add that I cross the sub very low for two channel, below 40Hz, to best blend with the speakers, so going by your 100Hz limit I could go with the mono setup. I would still use the JL room corrector.
Post removed 
Marty,

I read through some of the HT/Sub posts but dont find any info on bigger driver being faster, maybe I didnt looke close enough, can you point me in the right direction?
I have tried using the reciever with its EQ in the 2ch chain and the sound is clearly worse for me.

Bob,

when you say the room is too small for bass management from the subs and priferable to go with the full range EQ, what size would you think is approriate before that problem dissapears?

Also what do you guys think about mixing same brand subs but with different driver sizes, a 10" with a 12 or 13"?