Lightning quick DYNAMIC amp in the under $1000 range

The fact that Schiit posts measurements for the $100 Modi 3 but not for the Vidar and others makes me weary, like they’ll only show performance if it’s good for the price. 
 
$800 gets you a monoblock pair of Outlaw Model 2200 amps. 
 

" $800 gets you a monoblock pair of Outlaw Model 2200 amps. "

I will have to check those out...Monoblocks would be fantastic - but was thinking that might be out of my reach budget wise.

Rest of my system is Vandersteen 2C mains, Pre is an Onkyo TH 805 SR (HT receiver with preout over to the Behringer.)

Source I have a Technics SL-1200 MK2 with Nagaoka MP-150 which I love. I do use digital quite a bit with an Oppo BDP-93 with coax out to an Audio-GD Ladder DAC (R2R-11) which is also fantastic.

I also have a Chromecast audio for streaming Pandora and amazon prime going into the DAC via toslink.

I already know what I am going to get for the Pre - since I think that is my weakest link. I already made up my mind that I will buy a Schiit Saga tube pre-amp (which I will buy in April) so looking at an amp after that.

I love to listen loud, but I don't get the chance to do that very often do to my family always being around, so there will be mostly moderate volume levels, but I do want it to kick my ass when I finally get the house to myself.

My musical tastes are all over the map, but I love Mike Oldfield most (prog rock, I guess) and I am into some of the 80's stuff (Phil Collins Midnight Oil, INXS) I also love Rage against the Machine, Weezer, Cat Stevens, Alan Parsons and the Grateful Dead, just to name a few.

I've heard that tube amps while sounding extremely warm and musical, might not quote have the omph chest thumping dynamics that a good solid state has. I've heard if you want to get some tube sound into the system best to do it at the pre-amp level, so you can get all the benefits of good solid-state along with some of the tube goodness (Paul Mcgowen reference here).

bstatmeister OP
 The only one I can think of off the bat that might be good to try is the Schiit Vidar for $700.

+1 on that.

Cheers George

mzkmxcv
The fact that Schiit posts measurements for the $100 Modi 3 but not for the Vidar and others makes me weary, like they’ll only show performance if it’s good for the price.

Really!!!!

https://www.schiit.com/products/vidar   press specs tab

Power Output:

Stereo, 8 Ohms: 100W RMS per channelStereo, 4 Ohms: 200W RMS per channelMono, 8 ohms: 400W RMS Frequency Response: 20Hz-20Khz, -0.1db, 3Hz-500KHz, -3dB THD: <0.01%, 20Hz-20KHz, at 100W RMS into 8 ohms IMD: <0.01%, CCIR, at 100W RMS into 8 ohms SNR: >115db, A-weighted, referenced to full output Damping Factor: >100 into 8 ohms, 20-20kHz Gain: 22 (27dB)
Input Sensitivity: AKA Rated Output (Vrms)/Rated Gain. Or, 28V/22. You do the math. Input Impedance: 22k ohms SE, 44k ohms balanced Crosstalk: >95dB, 20-20kHz Inputs: L/R RCA jacks for stereo input, single XLR for mono input Topology: Fully complementary, all-BJT, current feedback, no coupling capacitors or DC servosOversight: microprocessor-controlled monitoring and management of critical operational points, including DC offset, with with relay shut-down for overcurrent, thermal, and other faultsPower Supply: 600VA transformer with dual mono main rails, plus boosted, regulated supply to input, voltage gain and driver stages, plus separate, isolated and regulated rails for microprocessor management. Power Consumption: 700W maximum Size: 9” x 13” x 3.875” Weight: 22 lbs

@georgehifi

Measurement graphs to be more clear, not chosen specs to publish. What’s the THD at 25W into 8ohm? I know the Benchmark AHB2 at 25W into 8ohm is less than 0.0002%, because Benchmark publishes the AP measurement graphs, and Stereophile’s own measurements confirm.

@bstatmeister

Emotiva also have the PA-1 monoblocks for I believe $600/pair, uses the same ICE module as in the PS Audio S300; of course the module used isn’t a 1:1 relation to performance, but I thought I’d mention it.