2. analog
  3. 149771-46

Tonearm for Technics 1200GR

I’m looking for a medium mass arm to replace the stock arm. Whatever arm is suggested it should have an armboard that can be bought for it as well. I run a Soundsmith Carmen MkII. 

Id like to keep the new arm under $1500. 

I found a Jelco TK 850s, but it appears to be a high mass arm. I also found a Timestep T-609, but it appears to be a high mass arm as well. 
last_lemming
last_lemming OP
639 posts
 
Forgive my ignorance here but the SME has a pivot to stylus dimension of 233.2 mm and the techniques has an effective length of 230 mm.   Are these names of these dimensions the same thing or do they represent two different dimensions?  If they are the same thing I’m assuming the arm board will compensate for this difference. 

Im I correct?
chakster's avatar
chakster
6,144 posts
 
No, if you're lookimg at pivot to stylus distance then you have to deduct the overhang. You need pivot to spindle distance. 
last_lemming OP
639 posts
 
Well, per the manual the overhang is 15mm. So does that make the p/s distance 215 mm?
chakster's avatar
chakster
6,144 posts
 
YES.

I think 225-230mm P/S distance is the limited factor in choosing new arm for Technics SL1200GR 

Technics stock arm has 225mm P/S distance. 
last_lemming OP
639 posts
 
So, when looking for a new arm, the p/s should be less than or equal to 225mm. So if the SME is 233.2 mm the the new armboard would need to adjust, is some direction away from the spindle, 8.2mm. 

Is is this generally correct?


More to discover