Glue choices for making the Garrard 301 plinth

@bdp24 
Thank you for the idea about the orientation of the wood layer. The main reason I want to try the hardwood plinth is based on Shindo plinth. Ken used cherry for all of his plinth and people who use his turntable have reported it sound so good.

@glennewdick Your turntable looks beautiful, and I guess it sounds delicious too. Your room and system is beautiful and well organized. Thank you for giving me the interesting idea about the plinth. I have never thought about bamboo before. I recall John Devore used bamboo for some of his speakers.

@glennewdick, I wasn't aware there was such a thing as bamboo plywood. That is VERY interesting! The appeal of Baltic Birch ply to me lies more in it's very thin and numerous plies than it's being made of birch wood. I believe bamboo is a harder wood than birch, so it may make for an even better material structurally. I'm going back to the hardwood store tomorrow afternoon, so I'll see if they are selling 13-ply bamboo plywood. Thanks for the tip!

For my Garrard 301 plinth I used compressed bamboo ply combined with birch ply. Compressed bamboo ply is harder than Maple, and heavier, more dense than regular bamboo ply.
For glue I used Titebond II Premium - this is a wood glue that cleans up with water, but once dry is highly water resistant.
Hide glue is hygroscopic - absorbs moisture and softens with heat, its not particlualr stable.
Marine epoxy would be anorther choice.

I am checking on the price of bamboo plywoods. It does nit reveal the price of the 4x8 or 5x5 sheet, but for a small piece, it is already too expensive. $21.95 for a 12x24 inches. 

Bamboo is quite expensive but worth the effort. in building. .and cutting ( it will burn through your tools fyi). I went with honey bamboo Ply.  bamboo ply is quite a bit thicker then other types of Ply also. I think the sheet sizes were 4x6 and about $100 (Canadian$ but bought from Seattle) a sheet. 

One other thing to try if you have the space is to put a small void (mine was 2" by 6") in the middle of the plinth layers i put mine under the tone arm, it can not be where your going to machine out the area for the table or arm. I filled the void with clean dry sand then sealed it in the build up. this adds some damping. note you don't want too much or it deadens the sound but a little helps with resonance in the table - plinth.