2. speakers
  3. 150274-129624

Replacement for Vandersteen 2ce

Hi everyone,
i have found this forum extremely helpful so I’m looking for some opinions on replacement speakers for my Older Vandersteen 2ce speakers. Been trying to do tweaks but wondering if I can improve the imaging and soundstage with something else maybe in the 2-4K region. 
Components are as listed:
Krell Digital Vanguard w/ Shunyata Delta NR PC
Acoustic Signature Triple X
SPL Phonos 
Marantz CD6006 w/ 
Digital from ITunes through RME DAC
Vandys have 15ft Taralabs RSC Primes which I was going to cut in half or replace but if I’m going to buy new speakers I’ll hold off.
I appreciate any help!
128x128audiosaurusrex
gratefuleric
112 posts
 
Love my Tekton double impact monitors, solid, detailed and lots of bottom end thump
mr_m
1,900 posts
 
How old are your 2 CE's? The newest versions are light years better sounding than the older models. But as John Rutan suggests, setup is critical, especially tilt back. I have the Treo CT's, and have never looked back.
audiosaurusrex's avatar
audiosaurusrex OP
320 posts
 
@mr_m The CE’s were purchased in 92-93 new from Ocean State Audio boxed for quite a few years and recently brought out. Did not like the old parasound HCA 1200 amp that powered them but my Krell has improved them significantly. Room is 16” wide x 14” deep snd have them 3 feet from back wall toed in slightly and tilted back a few degrees.
audionoobie's avatar
audionoobie
358 posts
 

I owned the 2ce Sig II for a couple years. I had my own issues with them, but soundstage and imaging was not one of them. They do this remarkably well IMO.

I agree it could be a setup issue and recommend you call John Rutan per above.

audionoobie's avatar
audionoobie
358 posts
 
Also, sorry for the obvious suggestion, make sure you dont have the polarity reversed on your speaker cables.
More to discover