A "blind" speaker recommendation based on specs...


I currently have a box-stock Peachtree Nova that I purchased back in April. I purchased a separate unit at the same time and sent it off to Canada for MEGA-MODS! Basically a 5 month/$5k with all the bells, buzzers whistles. Burson op-amps, all new resistors, caps, high-end next-gen WBT jacks/posts, Furutech IEC inlet, new tube, tube base, internal wiring, volatage switching removed, internal shielding et al. The whole enchilada! And yes, I do know there were & are other options out there. Pardon if my choice wouldn't have been "your" 1st choice.

Now, without mentioning names I'm wondering if I should keep my existing speakers which were new in April or at least consider an upgrade I've been researching closely. In order to maintain some semblence of subjectivity I'll keep speaker proper names out of this and list specs only in an effort to keep things honest/objective.

The Nova is a hybrid integrated SS amp/tube preamp with an honest 80wpc into 6 ohms.

My current speakers are high-end (for a bookshelf) on factory stands, 8 ohm with 88db sensitivity. The speakers I'm considering are also bookshelf on their own 200lb stands, vulgarly spendy uber high-end 4 ohm with 87db sensitivity.

Disregarding getting into speaker-to-speaker sound quality, how much harder/hotter is the integrated/hybrid likely to run with the 4 Ohm/87db setup than it does with the 8 Ohm/88db setup? Significant? Dramatic? Negligible?

TIA

salinas212
Post removed 
Me personally I learned a while ago specs don't mean a whole lot. Your ears should be the judge.
That being said I agree with Tvad regarding 4 ohm speakers with your amp.
Tvad has given you excellent advice. I would add that in the case of a 4 ohm speaker you have to be careful to note whether the sensitivity is specified relative to 1 watt input, or relative to 2.83 volts input (which is often the way sensitivity is specified, because 2.83V corresponds to 1W into 8 ohms).

If the spec is based on 2.83V, the sensitivity of the 4 ohm speaker is only 84dB for 1W input, which doubles the number of watts that are required to reach a given volume level, relative to what would be required with an 87dB/1W speaker.

Regards,
-- Al
A couple of examples:
I have two very different standmount speakers that are both rated 86db 6ohm. My little 12/20wpc 8/4ohm t-amp makes nice open, full music with one pair, sounds anemic and shut in with another.
The Totem One speakers I used to have could make some 100wpc amps sound small. My friend who has them now powers them with a 25wpc class A Bedini and they sound huge.
Specs can be deceiving, sometimes there is no substitute for hands on experience.
As has Almarg (given you excellent advice, that is). You need to look the minimum impedence of the speaker and the way that the sensitivity was reported. Even with that, if the potential upgrade is "uber-expensive" I'd want a return policy.