Proper Ground for Tonearm and Turntable


Hello all,
My first experience with a high end turntable an Acoustic Signature Triple X has a ground on the plinth as well does the Tonearm have a ground cable attached to the RCA cables. I am getting a pop thru my amp when the needle hits the record even if the amp is muted. Should both the plinth and the Tonearm be grounded to the phonostage? What is the correct way to ground this to eliminate the pop?
audiosaurusrex
Mijostyn you are very wrong on all counts. First and foremost, the tonearm requires a signal ground from the phono stage, and if you tie it to the plinth, you have just created a ground loop. Second, the phono stage needs to be grounded to the pre-amp / integrated amp. On an integrated amp, many manufacturers tie the common negative speaker leads to chassis ground. The OP was wise to consult the manufacturer on this, although the same result could probably have been achieved by grounding the phono stage chassis to a chassis screw on the preamp or integrated amp. Third, the Zerostat is a well-proven device to neutralize static buildup. A grounded sweep arm is not necessary, and in most cases it will do no good. 
@sleepwalker Yes I did not understand why there was no ground from the phonostage or table to the amp and it made sense to me that the “pop” could have been some sort of static buildup. I just did not to start willy nilly experimenting with connections from the turntable/phonostage to the amp. Krell did caution however do not do not connect ground to red/positive speaker terminals. “Explosion” lol. Either negative speaker terminal is tied to ground chassis. Just glad I resolved it. That pop was annoying!!
Sleep walker. ground has nothing to do with signal in a balanced set up. As you might notice most tonearms come with a separate ground wire not connected to the negative side of the RCA. it is like the shield on a balanced cable. Now some phono amps may have a common ground for signal and chassis. i suggest you stay away from them. Balanced outputs are the best with isolated chassis ground second. 
The Zerostat can temporarily reduce static which is regenerated as soon as the needle hits the groove. It is not my fault you have no concept of how static electricity is generated. I refer you to any high school science book. Functionally the Zerostat is stupid and a total waste of money. I am deeply sorry if you wasted your money on one. After you used your zerostat the static electricity was immediately regenerated as soon as your stylus hit the groove attracting dust smoke and god knows what else which your stylus promptly ground into the groove. Great way to ruin records. In the meanwhile Sleepwalker I suggest that you switch to digital media it is more fool proof.
Everyone knows that Zerostat is the first step to clean vinyl signal reproduction. If you weren’t drunk, you would realize that the “ground sweep arm” as you refer to, only neutralizes static charge that exists in the groove *before* the stylus, and is thus ineffective at neutralizing static charges caused by the friction of the stylus. Please get your facts straight.