can someone answer me this.....


i have done some extensive research and talked to quite a few people who own or have had this preamp.  I recently came into a conrad Johnson et 3 se, nt much clarity,the bass is muddy and the presentation is dark, ive read where some claim the system is to bright.  ive also read where its good to get a specific type of tube.  I don't want to do that just yet because im trying to learn the units characteristic.  I wonder if its not quite broken in yet.  maybe the impedance thing that Im just learning.  steve mccormck suggested that I try some after market power cord, that I ordered.  
assoc. equipment
McCormack dna 500
oppo 203
alon IV's
acoustic zen interconnects
I make my own speaker cables …..
no wires are touching, none are on the carpet or floor.....
kennesawjet
Avoid new manufactured tubes! Stick with NOS vintage tubes. Especially small-signal types like the 12A*7 and 6DJ8/6922 types! These front-end tubes are very critical to SQ in preamps and power amps!
Toss a Siemens 6922 in there-- one that you have had tested and know it is good.  For $100, you should be rocking.

MillerCarbon.....I have not found that to be true.   The connecting ends are the most important (I've tried Oyeida and Furutech.....both good, but I like top Furutech)
Dont drink the blue juice . Just roll some tubes. Power cords and crap are not going to make near as much difference as tubes. 
thank you all the your responses, cancel the power cord.  will have to just go with tube rolling again.  I know nothing about the 6922 tubes, I come from 12au7.  almarg, don't know a thing about the imped factor.  and do you still have that 17ls.  or what preamp goes best with the dna 500....