Alon/Nola sound


in general, associated amps notwithstanding, how would you characterize the Alon/Nola sound? Bright, warm, open, laid back, etc?

I was in an audio store the other day and in discussing my setup, the salesman felt that the Nola Viper iias were bright, which stunned me. I'v never thought they were bright, but definitely detailed and open. Do we all here that differently? Just curious.
hawk28
At any rate, I'm still looking for help with getting into this cabinet. Any thoughts out there, please let me know. Thanks.
According to the DVM, the midrange driver is fine. So, now that means going inside the speaker. Any ideas anyone?
One issue all Nola Viper series owners need to be aware of and that is that the Positive and Negative terminal tabs on the midrange drivers need to be adjusted so as not to come in contact with the cabinet. The midrange opening on the baffle is VERY tight around the back of the driver and the terminal tabs could come in contact with the inside of the midrange baffle opening.

This has a very adverse effect on the midrange if contact is being made as the cabinet vibrations are modulating the midrange driver terminals which results in a somewhat forward/hazy/hard midrange presentation and diminished musicality.

A quick and easy fix is one can take a small flat blade screwdriver and gently pry the terminal tabs up and away from the baffle opening or one can remove the drivers from the baffle and carefully bend the terminals with a pair of small flat tipped pliers. Only a small adjustment is necessary.

I have had this issue three times on my Viper 1X's with the first being the stock Ceramic midrange drivers, the 2nd when I swapped to the 2nd generation AlNiCo midrange drivers and again recently when I upgraded to the new rev lll AlNiCo midrange drivers. The driver tabs already come bent to a ~90 degree angle but additional adjustments have been necessary.

I urge all Viper series owners to inspect and adjust the midrange driver terminal tabs on their speakers as the results are NOT subtle, it's easy and it's free!

Cheers
The Vipers are working, thanks to a fellow audiogoner helping me with what to look for. There was a wire that came loose from one of the resistors on the crossover board. The vipers are sound pretty darn good, and I haven't even dialed them in yet.
I haven't posted in this thread for quite some time. I just need to let it be known that I have installed outriggers on the front of each speaker, and have tilted the speaker back slightly. Improvements were heard immediately. Soundstage and imaging improved substantially.