I’ve looked at some LPS options and they can get pricey.
Many options under USD $200. Single output units under $100.
You can go with an iFi switch mode wall wart for $49 to see if it beats the stock wall wart. Returnable, therefore minimal risk.
Ethernet Cable or Not?
Post removed |
“If I upgrade my WiFi receiver to a Blusound Node2 would that be a big step up, or would the LPS still be needed?” Node2 have been widely praised for its performance so I would say yes to better performance over your TB20. No LPS needed with Node 2, however upgrade from its stock PC is recommended. Something like this ..... http://www.cullencable.com/c7-power-cable/ If you choose to go Node 2 route, don’t forget the Supra Ethernet CAT8 Cable. |
sleepwalker65 Geoffy, how would you advise a cable manufacturer to determine the directionality of a piece of cable? >>>>Well, Sleepy, there are two ways to do it. The easiest way is to cut a section of WIRE off the spool - mark the section of wire to keep track of how it came off the spool - and measure the resistance both ways from end to end. The WIRE direction that has the least resistance is the proper direction. Then you know how to construct the cable. The other way is to make up an audio cable - marking how the WIRE came of the spool - and listen the cable both directions. The direction that sounds the best is the proper direction. Then you will know how to keep track of the wire as it comes off the spool. That how you control directionality of any cable or power cord or HDMI cable or Ethernet cable. |